Abstract:The flow fluidized bed reactor was applied to methanol-to-olefins research after some necessary improvements of traditional fixed flow bed reactor.Methanol decomposition probability before contacting the catalysts could be decreased to the lowest level by adjusting the pre-heater temperature and changing the material of descending feed pipe.The results of device repeatability and material balance investigation showed this reactor had good data repeatability and could achieve 97%of mass balance.The experiments about the effect of reaction temperature and water / methanol mass ratio on main products distribution were carried out based on the SAPO-34molecular sieve catalysts.The results of temperature experiments showed the temperature increase improved the ethylene selectivity greatly.As well as speed up the coke formation,the methanol conversion was almost 100%,and the C = 2 ～C = 4 selectivity could be over 90%.For eth-ylene as main product,the reaction temperature was suggested to choose 500 ℃ with C = 2 / C = 3 molar ratio of 1.5.For propylene as main product,the reaction temperature of 450～470 ℃ should be chosen with C = 2 / C = 3 molar ratio of 0.9～1.1.The results of water / methanol mass ratio experiment showed that increasing the water content could not only delay the coke formation rate,but also increase the ethylene selectivity remarkably,which could put the C = 2 / C = 3 molar ratio up to more than 2.0.Too much water would increase the energy consume and the load of reactor and products separator unavoidably no matter for ethylene or propylene as main products.Therefore,water / methanol mass ratio of 0.25～0.5was advocated.

FLUIDIZED BED APPARATUS AND METHOD FOR PREPARING PARA XYLENE CO PRODUCED LOW CARBON OLEFIN FROM METHANOL AND/OR DIMETHYL ETHER AND TOLUENE

FLUIDIZED BED DEVICE AND METHOD FOR PREPARING PARA XYLENE AND CO PRODUCING LIGHT OLEFINS FROM METHANOL AND/OR DIMETHYL ETHER AND TOLUENE

FLUIDIZED BED REACTOR AND METHOD FOR PRODUCING PARA XYLENE AND CO PRODUCING LIGHT OLEFINS FROM BENZENE AND METHANOL AND/OR DIMETHYL ETHER

Simulation of Fluidized Bed Reactor for Methanol to Olefins(MTO)Process

Simulation of multi-fluidized-bed in series for methanol to olefins

Turbulent fluidized bed reactor, device and method for preparing propylene and C4 hydrocarbons from oxygen containing compound

Enhanced Reaction Performances For Light Olefin Production From Butene Through Cofeeding Reaction With Methanol

Methanol to Propylene Process in a Moving Bed Reactor with Byproducts Recycling: Kinetic Study and Reactor Simulation

Efficient Conversion of Methane to Aromatics in the Presence of Methanol at Low Temperature

Method and equipment for preparing low carbon olefin from oxygenated compounds

Techno-Economic Analysis of Methanol to Propylene Process

Simulation and Analysis of the Regeneration Process of Methanol to Propylene

Method for increasing selectivity of low-carbon olefins in methanol or dimethyl ether converting process

Method to produce low-carbon olefin from methanol or DME

A Multi-Stage Fluidized Bed Strategy for the Enhanced Conversion of Methanol into Aromatics

High-yield Production of Aromatics from Methanol Using a Temperature-Shifting Multi-Stage Fluidized Bed Reactor Technology

Multiphase catalytic reactors for methanol to olefins

3D Numerical Simulation of a Large Scale MTO Fluidized Bed Reactor

Method for increasing yield of propylene

Method for partially regenerating catalyst of methanol to olefin and method of methanol to olefin

Performance analysis of methanol to olefins process in fluidized bed reactor