Abstract:This work examined liquefaction of polypropylene into liquid products in the presence of ethanol with particular attention to the effect of temperature (325-400 & nbsp;C), residence time (1-6 h) and solvent/feedstock mass ratio (1/ 1-4/1) on the overall product distribution, and composition of the oil products. The oil products obtained under the optimal reaction condition contained mainly alkanes, alkenes, alcohols and aromatics, which accounted for 42.41%, 22.81%, 3.51%, 1.05%, respectively. Increasing temperature and retention time enhanced aromatization reaction leading to increased yields of aromatic hydrocarbons. The higher heating value of the oil product was 45.72 MJ/Kg, which is comparable to the higher heating value (HHV) of gasoline. Volatility analysis shows that 50-85 wt% of the oil composition had similar boiling point range as gasoline (35-185 C). These characterization results suggest that the oil could be used as a raw material for gasoline blendstock or chemicals. The interaction of three reaction parameters on the oil formation was further evaluated by the response surface method. Through the Box-Behnken design, the R-2, F-value and p-value of analysis of variance were 0.9917, 93.20, and < 0.0001, respectively, showed that the model fitted well with actual experimental value. It is suggested that the reaction temperature affect the oil yield more significantly, compared to other two parameters. The response surface analysis showed that under the temperature of 376.7 C, residence time 3.8 h and solvent/feedstock mass ratio of 1/1, oil yield of 98.32 wt% can be achieved without adding catalyst or hydrogen. This predication was also verified by experiment.

FLUIDIZED BED REACTOR AND METHOD FOR PRODUCING PARA XYLENE AND CO PRODUCING LIGHT OLEFINS FROM BENZENE AND METHANOL AND/OR DIMETHYL ETHER

FLUIDIZED BED DEVICE AND METHOD FOR PREPARING PARA XYLENE AND CO PRODUCING LIGHT OLEFINS FROM METHANOL AND/OR DIMETHYL ETHER AND TOLUENE

FLUIDIZED BED APPARATUS AND METHOD FOR PREPARING PARA XYLENE CO PRODUCED LOW CARBON OLEFIN FROM METHANOL AND/OR DIMETHYL ETHER AND TOLUENE

Simulation of Fluidized Bed Reactor for Methanol to Olefins(MTO)Process

Simulation of multi-fluidized-bed in series for methanol to olefins

Methanol to Propylene Process in a Moving Bed Reactor with Byproducts Recycling: Kinetic Study and Reactor Simulation

Enhanced Reaction Performances For Light Olefin Production From Butene Through Cofeeding Reaction With Methanol

Methanol to propylene process using moving bed technology and its engineering study

Turbulent fluidized bed reactor, device and method for preparing propylene and C4 hydrocarbons from oxygen containing compound

Method for increasing selectivity of low-carbon olefins in methanol or dimethyl ether converting process

Method for increasing yield of propylene

High-yield Production of Aromatics from Methanol Using a Temperature-Shifting Multi-Stage Fluidized Bed Reactor Technology

Co-hydropyrolysis of Pine and HDPE over Bimetallic Catalysts: Efficient BTEX Production and Process Mechanism Analysis

Influence of temperature, residence time, and solvent/feedstock mass ratio on overall product distribution and oil products quality in ethanol liquefaction of 230 polypropylene impact copolymer

A Multi-Stage Fluidized Bed Strategy for the Enhanced Conversion of Methanol into Aromatics

Olefin Production Via Methanol Integrated with Light Hydrocarbon Conversion: Novel Process Designs, Techno-Economic Analysis, and Environmental Analysis

Decentralized Methanol Feed in a Two-Stage Fluidized Bed for Process Intensification of Methanol to Aromatics

Method to produce low-carbon olefin from methanol or DME

Performance analysis of methanol to olefins process in fluidized bed reactor

Dual-engine-driven realizing high-yield synthesis of Para-Xylene directly from CO2-containing syngas

Multiphase catalytic reactors for methanol to olefins