Abstract:In this work, a thin film transistor (TFT) with Zr-doped aluminum-zinc-tin oxide (Zr-AZTO) semiconductor as active layer was investigated. The Zr-AZTO thin films were co-sputtered by ZrO2 and AZTO targets (RF-Sputter) in Ar, and annealed at 350 degrees C in air atmosphere. With the discharge power of AZTO increasing from 100 W to 120 W, the content of Zr element decreases from 0.63 +/- 0.01 at.% to 0.34 +/- 0.01 at.%, and the oxygen vacancy decreases from (19.0 +/- 0.1)% to (17.3 +/- 0.8)%. The results of Zr-AZTO thin film show that the main factor is the co-sputter power of ZrO2 target. With the co-sputter power of ZrO2 increasing from 15 W to 45 W, the content of Zr element increases from 0.63 +/- 0.01 at.% to 2.79 +/- 0.01 at.%, the content of oxygen vacancy decreases from (19.0 +/- 0.1)% to (14.1 +/- 0.1)%, Eg increases from 2.76 eV to 2.86 eV, and the root mean square (RMS) roughness firstly decreases from 0.402 nm to 0.387 nm and then increases to 0.490 nm. The Micro Wave Photo Conductivity Decay (mu-PCD, LTA-1620SP) was used to measure the quality of Zr-AZTO thin film and the mean peak and D value decreases from 139.3 mV to 80.9 mV and from 1.54 to 0.77 as the co-sputter power of ZrO2 increases from 15 W to 45 W, which means it has highest localized states and defects in high ZrO2 co-sputter power. The devices prepared at 15 W (ZrO2)/100 W (AZTO) co-sputter show a best performance, with a mu(sat) of 8.0 +/- 0.6 cm(2)/(V.S), an Ion/loff of (2.01 +/- 0.34) x 10(6), and a SS of 0.18 +/- 0.03 V/dec. The device of Sample B has a 0.5 V negative shift under -20 V NBS and 9.6 V positive shift under 20 V PBS.

High-Performance Amorphous Zinc–Tin–Oxide Thin-Film Transistors with Low Tin Concentration

High-Performance Amorphous Zinc–Tin–Oxide Thin-Film Transistors With Low Tin Concentration

ZnSnO thin-film transistors by reactive co-sputtering of Zn and Sn metal targets

High-Performance Transistors Based on Zinc Tin Oxides by Single Spin-Coating Process

Study of zinc tin oxide thin-film transistor

High performance of ZnSnO thin-film transistors engineered by oxygen defect modulation

Self-Aligned Top-Gate Amorphous Zinc-Tin Oxide Thin-Film Transistor with Source/Drain Regions Doped by Al Reaction

Sn-Doped Zno Thin-Film Transistors with Azo, Tzo and Al Heterojunction Source/Drain Contacts

Solution-based SnGaO thin-film transistors for Zn- and In-free oxide electronic devices

Performances and Preparation of Zinc-Tin Oxide Thin-Film Transistors

Performance enhancement of ATZO TFTs by component control and post treatment

Thin-Film Transistors Based on Amorphous ZnNbSnO Films with Enhanced Behaviors

Simultaneous Enhancement of Electrical Performance and Stability of Zinc-Tin-oxide Thin-Film Transistors by Tantalum Doping

In-Situ Fluorine-Doped Znsno Thin Film and Thin-Film Transistor

Low Temperature and High Performance ZnSnO Thin Film Transistors Engineered by In-Situ Thermal Manipulation

Effects of film thickness and Sn concentration on electrical properties of solution-processed zinc tin oxide thin film transistors

Effect of Mg Content on Characteristics of Amorphous ZnMgSnO Thin-Film Transistors by a Combustion Solution Process

The Performance Of Zr-Doped Al-Zn-Sn-O Thin Film Transistor Prepared By Co-Sputtering

All‐Oxide Transparent Thin‐Film Transistors Based on Amorphous Zinc Tin Oxide Fabricated at Room Temperature: Approaching the Thermodynamic Limit of the Subthreshold Swing

Achieving High Performance of ZnSnO Thin-Film Transistor via Homojunction Strategy

High-mobility Solution-Processed Tin Oxide Thin-Film Transistors with High-Κ Alumina Dielectric Working in Enhancement Mode.