Abstract:In this paper, for the ITO-SiOx(In,Sn)/n-Si photovoltaic device, the molecular coacervate of In-O-Si bonding and two kinds of quantum states for indium-grafted in amorphous silicon oxide a-SiOx (In, Sn) layers are predicted by molecular dynamics simulation and density function theory calculation, respectively. The results show that the SiOx layers are the result of the inter-diffusion of the In, Sn, O, Si element. Moreover, In-O-Si and Sn-O-Si bonding hybird structures existing in the SiOx layers are found. From the result of formation energy calculations, we show that the formation energies of such an In-O-Si configuration are 5.38 eV for Si-rich condition and 4.27 eV for In-rich condition respectively, which are both lower than the energy (10 eV) provided in our experiment environment. It means that In-O-Si configuration is energetically favorable. By the energy band calculations, In and Sn doping induced gap states (E-v+4.60 eV for In, E-v+4.0 eV for Sn) within a-SiO 2 band gap are found, which are different from the results of doping of B, Al, Ga or other group-III and V elements. The most interesting phenomena are that there is either a transition level at E-v+0.3 eV for p-type conductive conversion or an extra level at E-v+4.60 eV induced by In doping within the dielectric amorphous oxide (a-SiOx) model. These gap states (GSII and GSIS) could lower the tunneling barrier height and increase the probability of tunneling, facilitate the transport of photo-generated holes, strengthen the short circuit current, and/or create negatively charged defects to repel electrons, thereby suppressing carrier recombination at the p-type inversion layer and promoting the establishment of the effective built-in-potential, increasing the open-circuit voltage and fill factor. Therefore, the multi-functions such as good passivation, built-in field, inversion layer and carriers tunneling are integrated into the a-SiOx (In, Sn) materials, which may be a good candidate for the selective contact of silicon-based high efficient heterojunction solar cells in the future. This work can help us to promote the explanations of the electronic structure and hole tunneling transport in ITO-SiOx/n-Si photovoltaic device and predict that In-O-Si compound could be as an excellent passivation tunneling selective material.

Electronic Structure of Molybdenum-Involved Amorphous Silica Buffer Layer in MoOx/n-Si Heterojunction

Investigation in Feasibility of Molybdenum As A Back Contact Layer for Silicon Based Quantum Dot Solar Cells

MoOx Hole Collection Layer for A-Si: H Based Photovoltaic Cells

Transport mechanisms in silicon heterojunction solar cells with molybdenum oxide as a hole transport layer

First Principle Study of Ternary Combined-State and Electronic Structure in Amorphous Silica

Simulation of High Efficiency Silicon Heterojunction Solar Cells with Molybdenum Oxide Carrier Selective Layer

Silicon solar cell with tunneling oxide on sulfur‐deficient intrinsic MoS2 thin film

Atom-to-Device Simulation of MoO3/Si Heterojunction Solar Cell

Construction of a MoOx/MoS2 Heterojunction via the Surface Sulfurization of the Oxide and Its Photocurrent-Switching Characteristics in the Range of the Broadband Light Spectrum

Molybdenum oxide hole selective transport layer by hot wire oxidation-sublimation deposition for silicon heterojunction solar cells

MoO3 with the Synergistic Effect of Sulfur Doping and Oxygen Vacancies: The Influence of S Doping on the Structure, Morphology, and Optoelectronic Properties

Transport mechanism in amorphous molybdenum silicide thin films

Greatly Enhanced Optical Absorption of A Defective Mos2 Monolayer Through Oxygen Passivation

MoOx modified ITO/a-Si:H(p) contact for silicon heterojunction solar cell application

Tuning oxygen vacancies in vanadium-doped molybdenum oxide for silicon solar cells with hole selective contact

Low Oxygen Content MoOx and SiOx Tunnel Layer Based Heterocontacts for Efficient and Stable Crystalline Silicon Solar Cells Approaching 22% Efficiency

Interface study of molybdenum oxide thin films on n- and p-type crystalline silicon surface

Study on the Thermal Stability of Molybdenum Oxide‐Passivated Silicon Solar Cells

Heterojunction solar cells with asymmetrically carrier-selective contact structure of molybdenum-oxide/silicon/magnesium-oxide

An Enhanced Charge Carrier Separation in a Heterojunction Solar Cell with a Metal Oxide

Tunable Hole Selective Transport by Solution‐processed MoO3‐x Via Doping for p‐Type Crystalline Silicon Solar Cells