The Impact of Cross Line Different-Phase Successive Faults on Fault Detection Devices
Lisheng Li,Haidong Yu,Yuxuan Jin,Bin Wang,Yang Liu,Linli Zhang
DOI: https://doi.org/10.1109/APAP59666.2023.10348496
2023-01-01
Abstract:At present, the technology of single phase ground fault line selection in small current earthing system is relatively mature, but when a single phase ground fault occurs in the system, the non fault phase voltage increases, which is likely to lead to breakdown of the non fault phase insulation weak point, forming a second ground fault, which turns into a cross line different-phase successive fault. For the detection of cross line different-phase successive fault, there are still some problems with the current line selection device. Often, only the first ground fault can be detected, while the second ground fault is not handled. When a cross line different-phase successive fault occurs on site, the line selection device often only selects the first ground fault line, and the staff judges another fault line, which results in a long fault duration and long power recovery time. It is not conducive to the safe and stable operation of the distribution network, so further research is needed for the detection of cross line different-phase successive fault. This article combines real fault cases and simulation data on site to analyze the causes and development process of cross line different phase successive fault. It also analyzes the changes in various electrical quantities during the process of transitioning from single-phase grounding faults to cross line different phase successive fault, and analyzes the impact of cross line different-phase successive fault on existing small current grounding line selection devices, Finally, improvement suggestions were proposed to address the occurrence of cross line different-phase successive fault.