Abstract:Although different damage-coupled physically based models have been proposed, those damage models are established based on the isothermal uniaxial or multi-axial tensile condition. However, the influence of the stress state on ductile failure strain is not adequately considered in the thermal damage models. It is widely recognized that the stress state has significant effect on damage evolution and ductility fracture for metallic materials. Actually, the current damage-coupled physically based models are not suitable for complex hot forming and the applications of these damage-coupled models are mainly focused on sheet hot stamping forming to date. Therefore, a modified damage-coupled unified model considering a broad range of stress states was established to figure out the complex damage behavior and microstructure evolution of metallic materials during the thermal deformation process. In this study, the Mg-6Gd-5Y-0.3Zr alloy was used as the experimental material. First, the flow behavior of the alloy was explored using a series of experiments under various stress states (i.e., uniaxial tensile, shear and compression) under various combinations of strain rates and temperatures. On this basis, a modified damage-coupled physics-based model was developed, in which the dynamic recrystallization, damage, stress triaxiality and Lode parameter were included as internal state variables. Furthermore, the model was integrated into ABAQUS to verify the applicability using hot spinnability test because the stress state was very complex during the forming process. The comparison between the calculated results and experiments is carried out. According to the simulation result, the predicted ultimate thinning rate is 71.14%, with an error of only 7.85% from the experimentally measured ultimate thinning rate of 77.2%, and the correlation coefficient and error for thickness and profile between the predicted values and experimental values are 0.9980 and 5.05%, respectively. These demonstrate that the developed model is reliable.

Anisotropic Damage and Failure Analysis of Magnesium Alloy Sheet Thermal Stamping

Failure prediction of magnesium alloys based on improved CDM model

Modeling of Anisotropic and Asymmetric Behaviour of Magnesium Alloys at Elevated Temperature Coupled with Ductile Damage

Forming Limit Prediction of Anisotropic Aluminum Magnesium Alloy Sheet AA5052-H32 Using Micromechanical Damage Model

A continuum damage model for Mg/Al composite sheets rolling: Theoretical development and application

Fracture Prediction in Spin Forming of Anisotropic Metal Sheets

Anisotropic Damage Model under Continuum Slip Crystal Plasticity Theory for Single Crystals

Prediction of edge cracks and plastic-damage analysis of Mg alloy sheet in rolling

A Thermal Damage-Coupled Constitutive Model for Predicting Fracture and Microstructure Evolution and Its Application in the Hot Spinnability Process

Modelling of dynamic behaviour of orthotropic metals including damage and failure

A damage sequence interaction model for predicting the mechanical property of in-service aluminium alloy 6005A-T6

Enhanced CDM model accounting of stress triaxiality and Lode angle for ductile damage prediction in metal forming

Investigation into the anisotropic damage behavior of LA103Z Mg‐Li alloy rolling sheet using X‐ray computed tomography and numerical modeling

Formability Prediction for Thermal Stamping of Magnesium Alloy Sheet Based on M-K Model

Investigation on tensile deformation and failure for 5052 aluminum alloy based on continuum damage model

Modelling of dynamic damage and failure in aluminium alloys

Modeling the anisotropic plasticity and damage of AA7075 alloy in hot forming

A Novel Damage Model To Predict Ductile Fracture Behavior For Anisotropic Sheet Metal

Influences of stress states and loading directions on the anisotropic fracture of magnesium alloy AZ31B sheet under tension-dominated forming conditions

Investigation of Mesoscopic Damage Evolution Mechanism of High Strength Steel in Hot Stamping Process

Forming Limit Analysis of Mg-2Zn-1.2Al-0.2Ca-0.2RE Alloy Sheet Using Ductile Fracture Models