Abstract:By using carbamide granules as the space holder, Mg alloy foams with interconnected pore structures were synthesized by reactive sintering of a mixture of Mg, Al and Zn powders. The effect of Zn/Al on the microstructural evolution and compressive strength of porous Mg-9Al-xZn (x = 1, 5) alloy foams was investigated. The phase diagram simulation approach was used to determine the sintering temperature. The analysis results show that the formation of binary secondary phases or intermetallic compounds is a crucial factor in achieving bonding strength for the porous Mg alloy foams. The intermetallic compounds were formed by solid-state diffusion between the metal powder elements. Mg17Al12 intermetallics was the most stable compound formed in the cell walls of porous Mg alloy foams. The addition of Zn influences the solubility and stability of the intermetallic compound. Thermodynamic calculations show that Mg17Al12 was preferentially formed in the cell walls owing to its high negative enthalpy energy. Moreover, various metastable transition phases may exist in the microstructures, especially in the porous Mg-9Al-5Zn alloy foam. The intermetallic phases act as reinforcing phases, combined with grain refinement, significantly increasing the strength of the foam. At the given relative density of 0.42, the porous Mg-9Al-5Zn alloy foam exhibits the highest yield strength of 9.0 MPa, which is 23% higher than the strength of the porous Mg-9Al-1Zn alloy foam.

Fabrication of Al Foam Without Thickening Process Through Melt-Foaming Method

Fabrication of Mg-Al Alloy Foam with Close-Cell Structure by Powder Metallurgy Approach and Its Mechanical Properties

Optimization of Mg Blowing Agent Content for Foaming Aluminum

Fabrication of Aluminum Foams with Small Pore Size by Melt Foaming Method

Optimizing Calcium Addition for Fabricating Aluminum Foams with Different Pore Sizes

Fabrication of Cu-Mg alloy foam with close pore structure by gas release reaction powder metallurgical approach

Fabrication of Cellular Zn–Mg Alloy Foam by Gas Release Reaction Via Powder Metallurgical Approach

Preparation principle and compression properties of cellular Mg–Al–Zn alloy foams fabricated by the gas release reaction powder metallurgy approach

Fabrication of Zn Alloy Foam Via Powder Metallurgical Approach

Development of AlMg35-TiH2 composite foaming agent and fabrication of small pore size aluminium foams

Foaming Process and Properties of 6063 Aluminum Foams by Melt Foaming Method

Effect of Magnesium Addition on the Cell Structure of Foams Produced From Re-melted Aluminum Alloy Scrap

Preparation of Aluminum Foam by Gas Injection Foaming

Fabrication of Uniform and Rounded Closed-Cell Aluminum Foams Using Novel Foamable Precursor Particles (FPPs)

Production, stability and properties of ultrafine MgAl 2 O 4 (spinel) particles stabilized Mg–3Ca alloy foams

Study on an Aluminum Foam by Gas Injection Foaming

Foamability and mechanical properties of in situ submicron MgAl2O4p/Al composite foams by ultrasonic method

Morphology of Aluminum Alloy Foams Produced with Dolomite via Partial Sintering of Precursors

Fabrication of porous aluminum composites containing hollow ceramics

Low-Temperature Reactive Sintered Porous Mg-Al-Zn Alloy Foams