Abstract:There is a wide range of processes to fabricate porous materials made of ceramics, polymers, and metals with an extensive range of applications. The Gasar method is one of the molten state methods of producing porous structures. Compared to other common commercial methods, the Gasar method allows effective control of the porosity, size, and orientation of the pores. One of the disadvantages of making gaseous foam is the creation of unwanted compounds in the structure of the produced foam limiting its application. Here, the fabrication of magnesium Gasar foam is studied using the thermal decomposition of polypropylene fibers (PPFs) as an additive foaming agent to produce hydrogen gas at atmospheric pressure. In this method, pores are formed due to the dissolution of hydrogen resulting from the thermal decomposition of PPFs in molten magnesium. The optimum amounts of fibers, working conditions of PPFs, preparation of the foaming agent, and the soaking method into the molten are explored and the parameters are optimized. TG, DTA, SEM, FTIR, EDS, and XRD are performed to analysis the foam structure. Also, the porosity amount and its diameter are calculated by CLEMEX software. The results show that by changing the amount of foaming agent from 0.4 to 10.2 wt%, the porosity rate changed from 0 to 23%. The highest porosity of 23% is attributed to 10.2 wt% of the foaming agent. Also, the average pore diameter at different levels of produced foams is investigated as a function of %PPFs. It is proposed that PPFs may be used to fabricate magnesium foams for load-bearing, weight-saving, and impact-absorbing applications.

Fabrication of Cellular Zn–Mg Alloy Foam by Gas Release Reaction Via Powder Metallurgical Approach

Fabrication of Cellular Mg Alloy by Gas Release Reaction Via Powder Metallurgical Approach

Fabrication of Zn Alloy Foam Via Powder Metallurgical Approach

Fabrication of Cu-Mg alloy foam with close pore structure by gas release reaction powder metallurgical approach

Fabrication of Mg-Al Alloy Foam with Close-Cell Structure by Powder Metallurgy Approach and Its Mechanical Properties

Preparation principle and compression properties of cellular Mg–Al–Zn alloy foams fabricated by the gas release reaction powder metallurgy approach

Low-Temperature Fabrication of Porous Mg-Zn Foams by a Reactive Sintering Powder Metallurgy Approach

Fabrication of Al Foam Without Thickening Process Through Melt-Foaming Method

Low-Temperature Reactive Sintered Porous Mg-Al-Zn Alloy Foams

Reactive sintering principle and compressive properties of porous AZ91 magnesium alloy foams produced by powder metallurgy approach

Effect of Zinc Content on the Mechanical Properties of Closed-Cell Aluminum Foams

Optimization of Cellular Structure of Aluminum Foams Produced by Powder Metallurgy Method

Performance Assessment on the Manufacturing of Zn-22Al-2Cu Alloy Foams Using Barite by Melt Route

Effect of Grain Size on the Mechanical Properties of Mg Foams

Optimization of Mg Blowing Agent Content for Foaming Aluminum

Production, stability and properties of ultrafine MgAl 2 O 4 (spinel) particles stabilized Mg–3Ca alloy foams

Fabrication of Aluminum Foams with Small Pore Size by Melt Foaming Method

Magnesium Metal Foam Production Using Polypropylene Fibers as an Active Hydrogen Source

Effect of Cu and Sn Additions on the Cellular Structure of Al–Si–Mg Alloys Foaming at Low Temperature (≤600 °C)

Development of AZ91D Magnesium Alloy-Graphene Nanoplatelets Composites Using Thixomolding Process