Abstract:The foamed structure of the central layer, predominantly governed by the addition levels of TiH 2 and the composition of the precursor, in addition to the parameters associated with the foaming process, constitutes the pivotal determinant impacting the spectrum of applications for aluminum foam sandwiches. Systematic research on the foaming behavior of the AlMg 4 Si 8 matrix and pure Al matrix precursors in closed cavities with different TiH 2 addition levels was conducted. The results reveal that with the increasing amount of TiH 2 , specifically at a 200% expansion rate of AlMg 4 Si 8 foams, the number of large pores decreased, the average pore size decreased from 0.67 mm 2 (0.6 wt%) to 0.43 mm 2 (1.0 wt%), and the total number of pores increased from 125 (0.6 wt%) to 156 (1.0 wt%). This trend of pore size consistency was evident not only at the mentioned 200% expansion rate but also across different expansion rates of AlMg 4 Si 8 foams and across all expansion rates of pure Al foams. The pore structures observed in the AlMg 4 Si 8 matrix and pure aluminum matrix foams within a closed cavity exhibited significantly superior characteristics compared to those achieved through free foaming processes. The circularity of pure Al foams was mainly distributed in the range of 1–2, being higher than the AlMg 4 Si 8 foams (1–1.5) due to their low viscosity and foam stability. The compressive curve of AlMg 4 Si 8 foams at a 400% expansion rate reveals that as the average cross-sectional area increased, there was a higher likelihood of experiencing initial collapse conditions. Additionally, the fluctuation of the platform area became more pronounced. Further, the slope corresponding to the elastic stage of the compressive curve increased as the overall stress levels increased.

Optimizing Calcium Addition for Fabricating Aluminum Foams with Different Pore Sizes

Effect of calcium addition on the aluminum alloy A201 foam

Factors affecting the microstructure of a fine ceramic foam

Fabrication of Aluminum Foams with Small Pore Size by Melt Foaming Method

Development of AlMg35-TiH2 composite foaming agent and fabrication of small pore size aluminium foams

Effect of Ca on Particulate Dispersion and Foam Stability in Gas Injection Foaming Process

Fabrication of Al Foam Without Thickening Process Through Melt-Foaming Method

Optimization of Cellular Structure of Aluminum Foams Produced by Powder Metallurgy Method

Effects of process parameters and alloy compositions on the pore structure of foamed aluminum

Characterization of as-cast microstructure of aluminum foams by melt foaming method

Microstructure and Compressive Properties of Aluminum Foams Made by 6063 Aluminum Alloy and Pure Aluminum

Fabrication of Mg-Al Alloy Foam with Close-Cell Structure by Powder Metallurgy Approach and Its Mechanical Properties

Effect of Cu and Sn Additions on the Cellular Structure of Al–Si–Mg Alloys Foaming at Low Temperature (≤600 °C)

Foaming Behavior of AlMg4Si8 Matrix and Pure Al Matrix Precursors in Closed Cavities with Different TiH2 Addition Levels

Aluminum Foam Sandwich: Pore Evolution Mechanism Investigation and Engineering Preparing Optimization

Fabrication of Uniform and Rounded Closed-Cell Aluminum Foams Using Novel Foamable Precursor Particles (FPPs)

Fabrication of Cu-Mg alloy foam with close pore structure by gas release reaction powder metallurgical approach

Study on an Aluminum Foam by Gas Injection Foaming

Foamability and mechanical properties of in situ submicron MgAl2O4p/Al composite foams by ultrasonic method

Controllable Design of Structural and Mechanical Behaviors of Al‐Si Foams by Powder Metallurgy Foaming