Controllable Design of Structural and Mechanical Behaviors of Al‐Si Foams by Powder Metallurgy Foaming

Xudong Yang,Mingrui Xie,Weiting Li,Junwei Sha,Naiqin Zhao

DOI: https://doi.org/10.1002/adem.202200125

IF: 3.6

2022-05-13

Advanced Engineering Materials

Abstract:Silicon (Si) has a significant influence on the cellular structure and microstructure of the Aluminum (Al) foams, which in turn will notably affect their mechanical responses. In the present work, the Al‐Si foams are fabricated via a novel powder metallurgy foaming approaches with multiple Si contents to investigate the role of Si concentrations on the structural and mechanical properties. The results show that the certain contents of Si could not only delay the expansion process, but also increase the maximum expansion rate to improve the cellular structure. Specifically, the AlSi7 foams process the optimal comprehensive compressive properties of yield stress (4.36 MPa), plateau stress (6.02 MPa) and energy absorption capacity (3.47 MJ m‐3) with the relative density of 0.15. However, excessive Si could decrease the expansion rate and deteriorate the cellular structure. Moreover, the deformation mode of the Al foams during compressive process from plastic mode to brittle mode by the adding of Si. Generally, the AlSi7 foams possess an excellent trade‐off between toughness and brittleness and exhibit the optimal mechanical responses. This article is protected by copyright. All rights reserved.

materials science, multidisciplinary