Abstract:Aluminum foam that is lightweight with high specific strength, high energy absorption and other characteristics can be used in aerospace, transportation, machinery manufacturing and other fields. The PCM method is usually used to prepare closed-cell aluminum foams. The microsized aluminum foams made by this process can solve the non-uniform pore structures caused by liquid drainage during the foaming process of large aluminum foams. The surface morphology and internal pore structure of microsized aluminum foams are affected by the quality of the precursor used for foaming. In this paper, foamable precursors were obtained via either hot rolling or hot extrusion and subsequently foamed. By analyzing the micromorphology and foaming process of the precursor, the influence of the technological method on the macroscopic pore structure of the final aluminum foam was studied. The results show that the aluminum powder particles in the precursor prepared with the hot rolling method had metallurgical bonding, and the outer surface was dense, with almost no porosity and holes in the interior. The microsized aluminum foam obtained after foaming was smooth in appearance, and the internal pore structure was round and uniform. The reason is that during the foaming process of microsize aluminum foam, the foaming agent was evenly distributed in the precursor of the hot rolling process because of its compact structure. During the foaming process, the decomposed gas of the foaming agent will not escape, and the evenly distributed foaming agent tends to nucleate in situ. In the process of rapid foaming, the pressure in the bubble is enough to resist the liquid drainage phenomenon caused by gravity, and the growth direction of the gas core is isotropic, which promotes the foam structure to be more rounded and uniform.

Morphology of Aluminum Alloy Foams Produced with Dolomite via Partial Sintering of Precursors

Factors affecting the microstructure of a fine ceramic foam

Fabrication of Uniform and Rounded Closed-Cell Aluminum Foams Using Novel Foamable Precursor Particles (FPPs)

Optimization of Cellular Structure of Aluminum Foams Produced by Powder Metallurgy Method

Fabrication of Mg-Al Alloy Foam with Close-Cell Structure by Powder Metallurgy Approach and Its Mechanical Properties

Fabrication and characterization of aluminum foam reinforced with nanostructured γ-Al2O3 via friction stir process for enhanced mechanical performance

Low-Temperature Reactive Sintered Porous Mg-Al-Zn Alloy Foams

Aluminum Foam Sandwich: Pore Evolution Mechanism Investigation and Engineering Preparing Optimization

Al and A356 Alloy Foam Castings Modified with Low Concentrations of Nano-Sized Particles: Structural Study and Compressive Strength Tests

Fabrication of Al Foam Without Thickening Process Through Melt-Foaming Method

Mesostructural Design and Manufacturing of Open-Pore Metal Foams by Investment Casting

Foaming Behavior of Microsized Aluminum Foam Using Hot Rolling Precursor

Preparation and Compressive Performance of an A356 Matrix Syntactic Foam

High mechanical performance alumina-reinforced aluminum nanocomposite metal foam produced by powder metallurgy: fabrication, microstructure characterization, and mechanical properties

Reinforcement Effect of Fly Ash with Different Morphologies on Aluminum Foam Prepared Via Powder Metallurgy

Characterization of as-cast microstructure of aluminum foams by melt foaming method

A Preliminary Study on Adhesion on Steel Cylinder Filled with Aluminum Foam

Fabrication of Aluminum Foams with Small Pore Size by Melt Foaming Method

Development of AlMg35-TiH2 composite foaming agent and fabrication of small pore size aluminium foams

Foaming Process and Properties of 6063 Aluminum Foams by Melt Foaming Method