Abstract:Aluminum foam is a lightweight material and has excellent shock-absorbing properties. Various properties of aluminum foam can be obtained by changing the base aluminum alloy. Multi-layer aluminum foam can be fabricated by varying the alloy type of the base aluminum alloy, but with different foaming temperatures, within a single aluminum foam to achieve multiple properties. In this study, we attempted to fabricate a two-layer aluminum foam with the upper layer of a commercially pure aluminum A1050 foam and the lower layer of an Al-Si-Cu aluminum alloy ADC12 foam by using an optical heating device that can heat from both the upper and lower sides. Two types of heating methods were investigated. One is to directly stack the A1050 precursor coated with black toner on top of the ADC12 precursor and to foam it from the top and bottom by optical heating. The other is to place a wire mesh between the ADC12 precursor and the A1050 precursor and place the A1050 precursor on the wire mesh, thereby creating a space between the precursors, which is then foamed by optical heating from the top and bottom. It was shown that both precursors can be foamed and joined, and a two-layer A1050/ADC12 foam can be fabricated for both types of heating methods. In the method in which two precursors were stacked and foamed, even if the light intensity of the halogen lamps on the top and bottom were adjusted, heat conduction occurred between the stacked precursors, and the foaming of each precursor could not be controlled, resulting in tilting of the joining interface. In the method of foaming using a wire mesh with a gap between two precursors, it was found that by adjusting the light intensity, the two precursors can be foamed almost simultaneously and achieve similar pore structures. The joining interface can also be maintained horizontally.

Foaming Process and Properties of 6063 Aluminum Foams by Melt Foaming Method

Microstructure and Compressive Properties of Aluminum Foams Made by 6063 Aluminum Alloy and Pure Aluminum

Fabrication of Aluminum Foams with Small Pore Size by Melt Foaming Method

Development of AlMg35-TiH2 composite foaming agent and fabrication of small pore size aluminium foams

Foaming Behavior of Microsized Aluminum Foam Using Hot Rolling Precursor

Properties of Aluminum Foam Prepared by Gas Injection Method

Study on an Aluminum Foam by Gas Injection Foaming

Characterization of as-cast microstructure of aluminum foams by melt foaming method

Fabrication of Uniform and Rounded Closed-Cell Aluminum Foams Using Novel Foamable Precursor Particles (FPPs)

Effects of process parameters and alloy compositions on the pore structure of foamed aluminum

Preparation of Aluminum Foam by Gas Injection Foaming

Fabrication of Two-Layer Aluminum Foam Consisting of Dissimilar Aluminum Alloys Using Optical Heating

Fabrication of Mg-Al Alloy Foam with Close-Cell Structure by Powder Metallurgy Approach and Its Mechanical Properties

Fabrication of Al Foam Without Thickening Process Through Melt-Foaming Method

Microstructural characteristics and mechanical properties of 7075 aluminum alloy foam sandwich panels fabricated via integrated forming and foaming

Preparation and Compressive Performance of an A356 Matrix Syntactic Foam

Preparation of complex shaped aluminum foam by a novel casting-foaming method

Fabrication and characterization of aluminum foam reinforced with nanostructured γ-Al2O3 via friction stir process for enhanced mechanical performance

Optimization of Mg Blowing Agent Content for Foaming Aluminum

Research on Key Technologies for Batch Preparation of Aluminum Foam Slabs by Melt Foaming Process