Abstract:A novel acoustic-vibration capacitive microelectromechanical system microphone is designed, fabricated, and implemented in this paper. The new microphone consists of a rigid diaphragm and mass blocks sensitive to low-frequency vibratory and sound signals. This sensor takes advantage of the semiconductor technology to design the capacitance sensor structure by surface micromachining technology, and the inertial mass blocks are shaped using the bulk silicon micromachining technology. The structure of the anti-stiction-dimple array is designed and deployed at the bottom of the diaphragm and the backplate to avoid the risk of sensor failure by vibration stiction. The bottom and top of the backplate are designed with an anti-humidity hydrophobic insulation protective layer, which avoids adsorption of moisture and attachment of foreign particles. The thickness of the mass blocks can be controlled by the combination of the dry and the wet micromachining method, which is sensitive to different frequency responses. This study can design and produce wafer level silicon with high consistency. The inertial mass proposed in this research can be achieved through a 6 in. wafer process with > 80% consistency when the thickness of the mass is around 300 mu m. The sensing frequency can be reduced to below the 4 kHz frequency bandwidth with enhanced sensitivity in the & PLUSMN;0.5 dB range. Typical characteristic results show that the open-circuit sensitivity of the microphone is 12.63 mV/Pa (37.97 dBV/Pa) at 1 kHz (with 94 dB as the reference sound level). The total harmonic distortion and acoustic overload point are 0.21% and 121.2 dB sound pressure level, respectively. The electronic stethoscope is a typical application of this research, which can collect the characteristics and frequency spectrum of low-frequency cardiac vibration signals. (C) 2022 Author(s).

DESIGN AND IMPLEMENTATION OF A CMOS-MEMS MICROPHONE WITHOUT THE BACK-PLATE

Implementation of the CMOS MEMS Condenser Microphone with Corrugated Metal Diaphragm and Silicon Back-Plate

Development Of A No-Back-Plate Soi Mems Condenser Microphone

Novel in-plane gap closing CMOS-MEMS microphone with no back-plate

Design and implementation of a novel CMOS MEMS condenser microphone with corrugated diaphragm

SENSITIVITY IMPROVEMENT OF NO-BACK-PLATE MEMS MICROPHONE USING POLYSILICON TRENCH-REFILLED PROCESS

Design and implementation of an acoustic-vibration capacitive MEMS microphone

Capacitive MEMS Microphone with Low-Stress Ultra-Thin Vibrating Membrane

Study of a highly sensitive miniature condenser microphone based on MEMS technology

Bandwidth and SNR Enhancement of MEMS Microphones Using Two Poly-Si Micromachining Processes

Design and Implementation of Differential MEMS Microphones Using the Two Polysilicon Processes for SNR Enhancement

Design and Implementation of A Capacitive-Type Microphone with Rigid Diaphragm and Flexible Spring Using the Two Poly Silicon Micromachining Processes

Development Of A Cmos Compatible Process For Silicon Miniature Microphone With A High Sensitivity

Design and implementation of a novel double-poly microphone with rigid acoustic receiver, flexible spring supporter, and harm backplate

Single-chip Condenser Miniature Microphone with a High Sensitive Circular Corrugated Diaphragm

Implementation of Two-Poly Differential MEMS Microphones for SNR and Sensing Range Enhancement

Design And Fabrication of Condenser Microphone Using Wafer Transfer And Micro-electroplating Technique

High-performance condenser microphone with fully integrated CMOS amplifier and DC-DC voltage converter

On the Single-Chip Condenser Miniature Microphone Using DRIE and Backside Etching Techniques

A Micro-machined Condenser Microphone with Polysilicon Diaphragm

Design and Fabrication of Silicon Condenser Microphone for Industrial Use