Abstract:The fabrication of insulation materials with ultralow thermal conductivity and excellent thermal stability at high temperatures (higher than 1200 °C) has remained an extremely challenging. In this study, we reported the manufacturing of mullite-based nanofibrous aerogels via the gel-casting and freeze drying methods using the electrospun nanofibers with different alumina/silica molar ratios (3:2, 3:1 and 3:0) as the matrix and silica sols as the high temperature binders. The formation process of the mullite-based fibrous aerogel and effect of aerogel composition on the sample physical and mechanical properties were investigated. All mullite-based nanofibrous aerogel show a similar multilevel pore structure. The minor pores were formed by the overlaps of nanofibers and were the fundamental porous structure of the aerogel, while the major pores was caused by the sublimation of the ice crystal. This unique multilevel pore structure make the mullite-based nanofibrous aerogels exhibit an ultralow density (34.64–48.89 mg/cm3) and low thermal conductivity (0.03274–0.04317 Wm−1 K−1) although the sintering temperature was as high as 1400 °C much higher than the service temperature of the traditional nanoparticle aerogel. In addition, besides controlling the fabrication parameters, the physical and mechanical properties could be also tuned by adjusting the composition of the nanofibers. The research of this work provides a new insight into the development of high efficient thermal insulation materials used at high temperatures.

Structure and thermal properties of millimeter-scale alumina aerogel beads formed by a modified ball dropping method

Highly Thermally Stable Alumina-Based Aerogels Modified by Partially Hydrolyzed Aluminum Tri-Sec-butoxide

Fabrication and Thermal Stability of La2O3 Doped Alumina Aerogel

Preparation and Heat Treatment of Titania Aerogels by Ambient Pressure Drying

Synthesis of monolithic aerogel-like alumina via the accumulation of mesoporous hollow microspheres

Preparation of Alumina Aerogel via Supercritical Method

Synthesis of Alumina Aerogels by Ambient Drying Method and Control of Their Structures

Synthesis of High-Surface-Area Alumina Aerogels without the Use of Alkoxide Precursors

Synthesis of alumina aerogel enriched carboxymethyl cellulose with polymodal pore size distribution by ambient pressure drying

Surface and pore structure of alumina derived from xerogel/aerogel

Organic/inorganic double-precursor cross-linked alumina aerogel with high specific surface area and high-temperature resistance

Preparation of monolithic Al2O3–SiO2 aerogels with high-temperature resistance using boehmite nanorods

A Facile Method to Fabricate Al2O3-SiO2 Aerogels with Low Shrinkage up to 1200 °C

Nano-sized amorphous alumina particles obtained by ball milling ZnO and Al powder mixture

Synthesis and characterization of SiO2-Al2O3 composite aerogel using inorganic aluminum salt as raw material

Investigation of the effect of lanthanum oxide on the thermal stability of alumina aerogel

Ultralight, thermal insulating, and high-temperature-resistant mullite-based nanofibrous aerogels

The Formation of Alumina Ceramic Microspheres by Internal Gelation Process

Synthesis of a novel Al 2 O 3 –SiO 2 composite aerogel with high specific surface area at elevated temperatures using inexpensive inorganic salt of aluminum

Alumina-Doped Silica Aerogels for High-Temperature Thermal Insulation

The low temperature fabrication of nanocrystalline MgAl2O4 spinel aerogel by a non-alkoxide sol-gel route