Abstract:In this research, a high-efficiency design method of the capacitive MEMS accelerometer is proposed. As the MEMS accelerometer has high precision and a compact structure, much research has been carried out, which mainly focused on the structural design and materials selection. To overcome the inconvenience and inaccuracy of the traditional design method, an orthogonal design and the particle swarm optimization (PSO) algorithm are introduced to improve the design efficiency. The whole process includes a finite element method (FEM) simulation, high-efficiency design, and verification. Through the theoretical analysis, the working mechanism of capacitive MEMS accelerometer is clear. Based on the comparison among the sweep calculation results of these parameters in the FEM software, four representative structural parameters are selected for further study, and they are le, nf, lf and wPM, respectively. le and lf are the length of the sensing electrode and fixed electrode on the right. nf is the number of electrode pairs, and wPM is the width of the mass block. Then, in order to reduce computation, an orthogonal design is adopted and finally, 81 experimental groups are produced. Sensitivity SV and mass Ma are defined as evaluation parameters, and structural parameters of experimental groups are imported into the FEM software to obtain the corresponding calculation results. These simulation data are imported into neural networks with the PSO algorithm. For a comprehensively accurate examination, three cases are used to verify our design method, and every case endows the performance parameters with different weights and expected values. The corresponding structural parameters of each case are given out after 24 iterations. Finally, the maximum calculation errors of SV and Ma are 1.2941% and 0.1335%, respectively, proving the feasibility of the high-efficiency design method.

Design of a High-Resolution Capacitive Microaccelerometer

Design of Force-Balance Capacitive Accelerometer

Study of a Novel Micromachined Capacitive Accelerometer

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

Design Of The Closed-Loop Capacitive Micro-Accelerometer Based On Pspice

An In-Plane Low-Noise Accelerometer Fabricated with an Improved Process Flow

The High-Efficiency Design Method for Capacitive MEMS Accelerometer

On the sensitivity improvement of CMOS capacitive accelerometer

Design and Fabrication Research on a Capacitive Accelerometer

Design and experiment of high-overload capacitive micro-machined accelerometers

Design and Virtual Fabrication Process of a New Kind of Capacitive Accelerometer

Design, Fabrication, And Performance Characterization Of Ltcc-Based Capacitive Accelerometers

Improvement of Capacitive Accelerometers: Integrating Modeling, Electrode Design, Signal Processing, and Material Selection

Design, Modeling and Analysis of Highly Reliable Capacitive Microaccelerometer Based on Circular Stepped-Plate and Small-Area Touch Mode

An Analytical Model for Studying the Structural Effects and Optimization of A Capacitive Tactile Sensor Array

Z-Axis Capacitive Accelerometer With Novel Beams Using Sog Structure

Design, Fabrication and Test of a Low Range Capacitive Accelerometer With Anti-Overload Characteristics

Consideration of the Fringe Effects of Capacitors in Micro Accelerometer Design

A Capacitive Micro-Accelerometer Based on LTCC Laminates

A new structure and modeling of a three-axis MEMS capacitive accelerometer with high dynamic range and sensitivity

A Novel Tunable Lateral Sensing Capacitive Silicon Micromachined Accelerometer with High Sensitivity