Abstract:In this research, a high-efficiency design method of the capacitive MEMS accelerometer is proposed. As the MEMS accelerometer has high precision and a compact structure, much research has been carried out, which mainly focused on the structural design and materials selection. To overcome the inconvenience and inaccuracy of the traditional design method, an orthogonal design and the particle swarm optimization (PSO) algorithm are introduced to improve the design efficiency. The whole process includes a finite element method (FEM) simulation, high-efficiency design, and verification. Through the theoretical analysis, the working mechanism of capacitive MEMS accelerometer is clear. Based on the comparison among the sweep calculation results of these parameters in the FEM software, four representative structural parameters are selected for further study, and they are le, nf, lf and wPM, respectively. le and lf are the length of the sensing electrode and fixed electrode on the right. nf is the number of electrode pairs, and wPM is the width of the mass block. Then, in order to reduce computation, an orthogonal design is adopted and finally, 81 experimental groups are produced. Sensitivity SV and mass Ma are defined as evaluation parameters, and structural parameters of experimental groups are imported into the FEM software to obtain the corresponding calculation results. These simulation data are imported into neural networks with the PSO algorithm. For a comprehensively accurate examination, three cases are used to verify our design method, and every case endows the performance parameters with different weights and expected values. The corresponding structural parameters of each case are given out after 24 iterations. Finally, the maximum calculation errors of SV and Ma are 1.2941% and 0.1335%, respectively, proving the feasibility of the high-efficiency design method.

On the sensitivity improvement of CMOS capacitive accelerometer

A Stiffness-Tunable MEMS Accelerometer

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

An In-Plane Low-Noise Accelerometer Fabricated with an Improved Process Flow

Design of Force-Balance Capacitive Accelerometer

Design Of The Closed-Loop Capacitive Micro-Accelerometer Based On Pspice

Improvement of CMOS-MEMS accelerometer using the symmetric layers stacking design

Analysis and Amelioration about the Cross-Sensitivity of A High Resolution Moems Accelerometer Based on Diffraction Grating

A Novel Cmos Mems Accelerometer With Four Sensing Finger Arrays

Design and Application of a Metal Wet-Etching Post-Process for the Improvement of CMOS-MEMS Capacitive Sensors

A Novel Cmos Out-Of-Plane Accelerometer with Fully Differential Gap-Closing Capacitance Sensing Electrodes

Design And Implementation Of A Novel Cmos-Mems Single Proof-Mass Tri-Axis Accelerometer

Post-Cmos Selective Electroplating Technique for the Improvement of Cmos-Mems Accelerometers

The High-Efficiency Design Method for Capacitive MEMS Accelerometer

Implementation of A Monolithic Single Proof-Mass Tri-Axis Accelerometer Using Cmos-Mems Technique

A new structure and modeling of a three-axis MEMS capacitive accelerometer with high dynamic range and sensitivity

Design of a Capacitive MEMS Accelerometer with Softened Beams

The Cmos-Mems 3-Axis Capacitive Accelerometer To Meet The Commercial Specifications

Vertical Integration of Force Transmission Structure on Capacitive Cmos-Mems Tactile Force Sensor for Sensitivity Improvement

A CMOS-MEMS accelerometer with tri-axis sensing electrodes arrays

A Novel Tunable Lateral Sensing Capacitive Silicon Micromachined Accelerometer with High Sensitivity