Abstract:A complementary metal-oxide-semiconductor (CMOS)-microelectromechanical system (MEMS) accelerometer with stacked pure oxide layers as mechanical structures was developed. Metal layers were confined to the sensing electrodes and electrical routings; the metal-oxide composite in the CMOS-MEMS accelerometer was distributed in limited regions. This design has two major advantages: 1) the thermal deformation of suspended MEMS structures resulting from a mismatch in the coefficients of thermal expansion of the metal and the oxide in the metal-oxide films is suppressed; and 2) the parasitic capacitance of the sensing electrode routing underneath the proof mass is reduced. Thus, the accelerometer has higher sensitivity and reduced thermal drift. The curvature of the mechanical structures are improved in the temperature span and the noise floor is lowered. In the full temperature span (30 °C-90 °C), change in the radius of curvature per unit change in the temperature was 0.08%/°C for the in-plane accelerometer and 0.37%/°C for the out-of-plane accelerometer. Compared with the typical metal-oxide design, the proposed pure oxide design yielded a >20-fold improvement in radius of curvature change per unit temperature change for the in-plane accelerometer and a fivefold improvement for the out-of-plane accelerometer. Moreover, the noise floor was reduced to 0.40 (x-axis), 0.21 (y-axis), and 0.94 mG Hz-1/2 (z-axis), respectively, a 2.2-7.6-fold improvement compared with the metal-oxide design.

The Cmos-Mems 3-Axis Capacitive Accelerometer To Meet The Commercial Specifications

Monolithic Integrated Cavity Optomechanical Accelerometer Based on Push-Pull Photonic Crystal Zipper Cavity

Design And Implementation Of A Novel Cmos-Mems Single Proof-Mass Tri-Axis Accelerometer

Implementation of A Monolithic Single Proof-Mass Tri-Axis Accelerometer Using Cmos-Mems Technique

Monolithic Integrated Micro-Opto-Electromechanical Accelerometer Based on Michelson Interferometer Structure

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

An In-Plane Low-Noise Accelerometer Fabricated with an Improved Process Flow

3-axis Capacitive Low-Gravity MEMS Accelerometer with Zero Cross-Axis Sensitivity in a Commercial Process

A CMOS-MEMS accelerometer with tri-axis sensing electrodes arrays

A Novel Cmos Out-Of-Plane Accelerometer with Fully Differential Gap-Closing Capacitance Sensing Electrodes

A Three-Axis CMOS-MEMS Accelerometer Structure With Vertically Integrated Fully Differential Sensing Electrodes

A 3-axis MEMS capacitive accelerometer free of cross axis sensitivity

A novel SOI-based single proof-mass 3-axis accelerometer with gap-closing differential capacitive electrodes in all sensing directions

A Novel Cmos Mems Accelerometer With Four Sensing Finger Arrays

Improvement of CMOS-MEMS accelerometer using the symmetric layers stacking design

A new structure and modeling of a three-axis MEMS capacitive accelerometer with high dynamic range and sensitivity

New capacitive low-g triaxial accelerometer with low cross-axis sensitivity

A Monolithic 3d Fully-Differential Cmos Accelerometer

Design and Fabrication of a Micro-Electromechanical System Sandwich Capacitive Accelerometer

A Wafer Level Vacuum Encapsulated Capacitive Accelerometer Fabricated in an Unmodified Commercial MEMS Process

Monolithic Cmos-Mems Pure Oxide Tri-Axis Accelerometers for Temperature Stabilization and Performance Enhancement