Abstract:Cross-axis sensitivity of single-axis optomechanical accelerometers, mainly caused by the asymmetric structural design, is an essential issue primarily for high performance applications, which has not been systematically researched. This paper investigates the generating mechanism and detrimental effects of the cross-axis sensitivity of a high resoluion single-axis optomechanical accelerometer, which is composed of a grating-based cavity and an acceleration sensing chip consisting of four crab-shaped cantilevers and a proof mass. The modified design has been proposed and a prototype setup has been built based on the model of cross-axis sensitivity in optomechanical accelerometers. The characterization of the cross-axis sensitivity of a specific optomechanical accelerometer is quantitatively discussed for both mechanical and optical components by numerical simulation and theoretical analysis in this work. The analysis indicates that the cross-axis sensitivity decreases the contrast ratio of the interference signal and the acceleration sensitivity, as well as giving rise to an additional optical path difference, which would impact the accuracy of the accelerometer. The improved mechanical design is achieved by double side etching on a specific double-substrate-layer silicon-on-insulator (SOI) wafer to move the center of the proof mass to the support plane. The experimental results demonstrate that the modified design with highly symmetrical structure can suppress the cross-axis sensitivity significantly without compromising the sensitivity and resolution. The cross-axis sensitivity defined by the contrast ratio of the output signal drops to 2.19%/0.1g from 28.28%/0.1g under the premise that the acceleration sensitivity of this single-axis optomechanical accelerometer remains 1162.45V/g and the resolution remains 1.325 mu g. (C) 2016 Optical Society of America

New capacitive low-g triaxial accelerometer with low cross-axis sensitivity

An In-Plane Low-Noise Accelerometer Fabricated with an Improved Process Flow

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

Minimizing cross-axis sensitivity in grating-based optomechanical accelerometers.

3-axis Capacitive Low-Gravity MEMS Accelerometer with Zero Cross-Axis Sensitivity in a Commercial Process

Implementation of A Monolithic Single Proof-Mass Tri-Axis Accelerometer Using Cmos-Mems Technique

Monolithic Integrated Micro-Opto-Electromechanical Accelerometer Based on Michelson Interferometer Structure

Analysis and Amelioration about the Cross-Sensitivity of A High Resolution Moems Accelerometer Based on Diffraction Grating

A Stiffness-Tunable MEMS Accelerometer

A 3-axis MEMS capacitive accelerometer free of cross axis sensitivity

Development of a High-Precision and Low Cross-Axis Sensitivity 3-D Accelerometer for Low-Frequency Vibration Measurement

Design And Implementation Of A Novel Cmos-Mems Single Proof-Mass Tri-Axis Accelerometer

A silicon-on-glass Z-axis accelerometer with vertical sensing comb capacitors.

Design and Fabrication of a Highly Symmetrical Capacitive Triaxial Accelerometer

Double-Comb-Finger Design to Eliminate Cross-Axis Sensitivity in a Dual-Axis Accelerometer

A two degrees of freedom comb capacitive-type accelerometer with low cross-axis sensitivity

Design of a Novel Low Cross-Axis Sensitivity Micro-Gravity Sandwich Capacitance Accelerometer.

The Design and Fabrication of A Miniaturized Differential-Capacitive Triaxial Accelerometer

A new structure and modeling of a three-axis MEMS capacitive accelerometer with high dynamic range and sensitivity

The Cmos-Mems 3-Axis Capacitive Accelerometer To Meet The Commercial Specifications

A CMOS-MEMS accelerometer with tri-axis sensing electrodes arrays