Abstract:The ultrahigh static displacement-acceleration sensitivity of a mechanical sensing chip is essential primarily for an ultra-sensitive accelerometer. In this paper, an optimal design to implement to a single-axis MOEMS accelerometer consisting of a grating interferometry cavity and a micromachined sensing chip is presented. The micromachined sensing chip is composed of a proof mass along with its mechanical cantilever suspension and substrate. The dimensional parameters of the sensing chip, including the length, width, thickness and position of the cantilevers are evaluated and optimized both analytically and by finite-element-method (FEM) simulation to yield an unprecedented acceleration-displacement sensitivity. Compared with one of the most sensitive single-axis MOEMS accelerometers reported in the literature, the optimal mechanical design can yield a profound sensitivity improvement with an equal footprint area, specifically, 200% improvement in displacement-acceleration sensitivity with moderate resonant frequency and dynamic range. The modified design was microfabricated, packaged with the grating interferometry cavity and tested. The experimental results demonstrate that the MOEMS accelerometer with modified design can achieve the acceleration-displacement sensitivity of about 150 mu m/g and acceleration sensitivity of greater than 1500V/g, which validates the effectiveness of the optimal design.

Design And Implementation Of A Novel Cmos-Mems Single Proof-Mass Tri-Axis Accelerometer

Implementation of A Monolithic Single Proof-Mass Tri-Axis Accelerometer Using Cmos-Mems Technique

A CMOS-MEMS accelerometer with tri-axis sensing electrodes arrays

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

A novel SOI-based single proof-mass 3-axis accelerometer with gap-closing differential capacitive electrodes in all sensing directions

The Cmos-Mems 3-Axis Capacitive Accelerometer To Meet The Commercial Specifications

Micromachined Tri-Axis Capacitive Accelerometer Based on the Single Mass

A Monolithic Cmos-Mems 3-Axis Accelerometer with A Low-Noise, Low-Power Dual-Chopper Amplifier

Design and simulation of a novel MEMS-based single proof mass three-axis piezo-capacitive accelerometer

3-axis Capacitive Low-Gravity MEMS Accelerometer with Zero Cross-Axis Sensitivity in a Commercial Process

A Novel Cmos Out-Of-Plane Accelerometer with Fully Differential Gap-Closing Capacitance Sensing Electrodes

Microfabrication and Characterization of an Integrated 3-Axis CMOS-MEMS Accelerometer

A Novel Cmos Mems Accelerometer With Four Sensing Finger Arrays

A 3-axis MEMS capacitive accelerometer free of cross axis sensitivity

Design and fabrication of an integrated CMOS-MEMS 3-axis accelerometer

MEMS above CMOS process for single proof-mass 3-AXIS Lorentz-force resonant magnetic sensor

A Three-Axis CMOS-MEMS Accelerometer Structure With Vertically Integrated Fully Differential Sensing Electrodes

A single-crystal silicon 3-axis CMOS-MEMS accelerometer

A Novel Soi Z-axis Accelerometer with Gap Closing Differential Sensing Electrodes

A MEMS Micro-g Capacitive Accelerometer Based on Through-Silicon-Wafer-Etching Process

Design And Fabrication Of A Slanted-Beam Mems Accelerometer