Abstract:A micromachined electrostatically-suspended accelerometer (MESA) is a kind of three-axis inertial sensor based on fully-contactless electrostatic suspension of the proof mass (PM). It has the potential to offer broad bandwidth, high sensitivity, wide dynamic range and, thus, would be perfectly suited for land seismic acquisition. Previous experiments showed that it is hard to lift up the PM successfully during initial levitation as the mass needs to be levitated simultaneously in all six degrees of freedom (DoFs). By analyzing the coupling electrostatic forces and torques between three lateral axes, it is found there exists a self-locking zone due to the cross-axis coupling effect. To minimize the cross-axis coupling and solve the initial levitation problem, this paper proposes an effective control scheme by delaying the operation of one lateral actuator. The experimental result demonstrates that the PM can be levitated up with six-DoF suspension operation at any initial position. We also propose a feed-forward compensation approach to minimize the negative stiffness effect inherent in electrostatic suspension. The experiment results demonstrate that a more broadband linear amplitude-frequency response and higher suspension stiffness can be achieved, which is crucial to maintain high vector fidelity for potential use as a three-component MEMS geophone. The preliminary performance tests of the three-axis linear accelerometer were conducted under normal atmospheric pressure and room temperature. The main results and noise analysis are presented. It is shown that vacuum packaging of the MEMS sensor is essential to extend the bandwidth and lower the noise floor, especially for low-noise seismic data acquisition.

A Sensitive Three-Axis Micromachined Accelerometer Based on an Electrostatically Suspended Proof Mass

Performance of a Sensitive Micromachined Accelerometer with an Electrostatically Suspended Proof Mass

Experimental Study of A Low-G Micromachined Electrostatically Suspended Accelerometer for Space Applications

Design, Fabrication And Levitation Experiments Of A Micromachined Electrostatically Suspended Six-Axis Accelerometer

Experiment Study of a Tri-Axis Electrostatically Suspended Micromachined Accelerometer

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

Self-Locking Avoidance and Stiffness Compensation of a Three-Axis Micromachined Electrostatically Suspended Accelerometer

Design of Electrostatic Levitation Loop for Six-Axis Micromachined Accelerometer

Novel Capacitive Sensing System Design of A Microelectromechanical Systems Accelerometer for Gravity Measurement Applications

Design of Proof Mass and System-Level Simulation of A Micromachined Electrostatically Suspended Accelerometer

Micromachined Tri-Axis Capacitive Accelerometer Based on the Single Mass

A Ground-Based Electrostatically Suspended Accelerometer

Design for Electrostatically Levitated Micromechanical Accelerometer

Design And Implementation Of A Novel Cmos-Mems Single Proof-Mass Tri-Axis Accelerometer

A MEMS Micro-g Capacitive Accelerometer Based on Through-Silicon-Wafer-Etching Process

Design and Numerical Performance Analysis of a Microgravity Accelerometer with Quasi-Zero Stiffness

3-axis Capacitive Low-Gravity MEMS Accelerometer with Zero Cross-Axis Sensitivity in a Commercial Process

Design and Fabrication of a Micro-Electromechanical System Sandwich Capacitive Accelerometer

A Subnano-g Electrostatic Force-Rebalanced Flexure Accelerometer for Gravity Gradient Instruments.

A Biaxial Capacitive Microaccelerometer with A Single Proof-Mass

An optimized micromachined convective accelerometer with no proof mass