Abstract:A micromachined electrostatically-suspended accelerometer (MESA) is a kind of three-axis inertial sensor based on fully-contactless electrostatic suspension of the proof mass (PM). It has the potential to offer broad bandwidth, high sensitivity, wide dynamic range and, thus, would be perfectly suited for land seismic acquisition. Previous experiments showed that it is hard to lift up the PM successfully during initial levitation as the mass needs to be levitated simultaneously in all six degrees of freedom (DoFs). By analyzing the coupling electrostatic forces and torques between three lateral axes, it is found there exists a self-locking zone due to the cross-axis coupling effect. To minimize the cross-axis coupling and solve the initial levitation problem, this paper proposes an effective control scheme by delaying the operation of one lateral actuator. The experimental result demonstrates that the PM can be levitated up with six-DoF suspension operation at any initial position. We also propose a feed-forward compensation approach to minimize the negative stiffness effect inherent in electrostatic suspension. The experiment results demonstrate that a more broadband linear amplitude-frequency response and higher suspension stiffness can be achieved, which is crucial to maintain high vector fidelity for potential use as a three-component MEMS geophone. The preliminary performance tests of the three-axis linear accelerometer were conducted under normal atmospheric pressure and room temperature. The main results and noise analysis are presented. It is shown that vacuum packaging of the MEMS sensor is essential to extend the bandwidth and lower the noise floor, especially for low-noise seismic data acquisition.

Design for Electrostatically Levitated Micromechanical Accelerometer

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

Design of Force-Balance Capacitive Accelerometer

Design of Electrostatic Levitation Loop for Six-Axis Micromachined Accelerometer

Monolithic Integrated Micro-Opto-Electromechanical Accelerometer Based on Michelson Interferometer Structure

Optical Design and Analysis of a High Resolution MOEMS Accelerometer Based on Diffraction Grating

A Sensitive Three-Axis Micromachined Accelerometer Based on an Electrostatically Suspended Proof Mass

Experiment Study of a Tri-Axis Electrostatically Suspended Micromachined Accelerometer

Performance of a Sensitive Micromachined Accelerometer with an Electrostatically Suspended Proof Mass

Structural Design and Testing of a Micromechanical Resonant Accelerometer

A micromachined resonant accelerometer

Self-Locking Avoidance and Stiffness Compensation of a Three-Axis Micromachined Electrostatically Suspended Accelerometer

Design and Realization of Comb-Finger Micromechanical Accelerometer

Verilog-A modeling and design of a micromachined capacitive accelerometer

Design considerations of electrostatic forces in microaccelerometers

Experimental Study of A Low-G Micromachined Electrostatically Suspended Accelerometer for Space Applications

Preliminary Research of Magnetic Levitation Accelerometer

A Ground-Based Electrostatically Suspended Accelerometer

Design Of A High-Sensitivity Micromechanical Resonant Accelerometer With A Two-Stage Microlever

Measuring Principle and Dynamic Characteristics Design for An Electro-Statically Suspended Accelerometer with Differential-Capacitance

Analysis and Design of an Electrostatic Space Accelerometer