Abstract:A micromachined electrostatically-suspended accelerometer (MESA) is a kind of three-axis inertial sensor based on fully-contactless electrostatic suspension of the proof mass (PM). It has the potential to offer broad bandwidth, high sensitivity, wide dynamic range and, thus, would be perfectly suited for land seismic acquisition. Previous experiments showed that it is hard to lift up the PM successfully during initial levitation as the mass needs to be levitated simultaneously in all six degrees of freedom (DoFs). By analyzing the coupling electrostatic forces and torques between three lateral axes, it is found there exists a self-locking zone due to the cross-axis coupling effect. To minimize the cross-axis coupling and solve the initial levitation problem, this paper proposes an effective control scheme by delaying the operation of one lateral actuator. The experimental result demonstrates that the PM can be levitated up with six-DoF suspension operation at any initial position. We also propose a feed-forward compensation approach to minimize the negative stiffness effect inherent in electrostatic suspension. The experiment results demonstrate that a more broadband linear amplitude-frequency response and higher suspension stiffness can be achieved, which is crucial to maintain high vector fidelity for potential use as a three-component MEMS geophone. The preliminary performance tests of the three-axis linear accelerometer were conducted under normal atmospheric pressure and room temperature. The main results and noise analysis are presented. It is shown that vacuum packaging of the MEMS sensor is essential to extend the bandwidth and lower the noise floor, especially for low-noise seismic data acquisition.

A New Structure of Test Mass for Ground-used Electrostatically Suspended Accelerometer

A Ground-Based Electrostatically Suspended Accelerometer

Performance of a Sensitive Micromachined Accelerometer with an Electrostatically Suspended Proof Mass

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

Experimental Study of A Low-G Micromachined Electrostatically Suspended Accelerometer for Space Applications

Self-Locking Avoidance and Stiffness Compensation of a Three-Axis Micromachined Electrostatically Suspended Accelerometer

Analysis and Design of an Electrostatic Space Accelerometer

Experiment Study of a Tri-Axis Electrostatically Suspended Micromachined Accelerometer

A Sensitive Three-Axis Micromachined Accelerometer Based on an Electrostatically Suspended Proof Mass

Measuring Principle and Dynamic Characteristics Design for An Electro-Statically Suspended Accelerometer with Differential-Capacitance

Design of Electrostatic Levitation Loop for Six-Axis Micromachined Accelerometer

Study on suspension technique of space electrostatic accelerometer

Electrostatic Space Accelerometers with Adaptive Preload Control

Identification and adjustment of the position and attitude for the electrostatic accelerometer's proof mass

A Novel Z-Axis Capacitance Accelerometer with Highly Symmetrical 16-Beam Structure

Design and Fabrication of a Differential Electrostatic Accelerometer for Space-Station Testing of the Equivalence Principle

A New Symmetrical Beam-Mass Structure for Accelerometers by Anisotropic Etching Without Convex Corner Compensation

An Ultralow-Frequency Active Vertical Vibration Isolator with Geometric Antispring Structure for Absolute Gravimetry

Research of electrostatically suspended mercury accelerometer

Design for Electrostatically Levitated Micromechanical Accelerometer

A micromachined resonant accelerometer