Abstract:With the increasing demand for multidirectional vibration measurements, traditional triaxial accelerometers cannot achieve vibration measurements with high sensitivity, high natural frequency, and low cross-sensitivity simultaneously. Moreover, for piezoresistive accelerometers, achieving pure axial deformation of the piezoresistive beam can greatly improve performance, but it requires the piezoresistive beam to be located in a specific position, which inevitably makes the design more complex and limits the performance improvement. Here, a monolithically integrated triaxial high-performance accelerometer with pure axial stress piezoresistive beams was designed, fabricated, and tested. By controlling synchronous displacements at both piezoresistive beam ends, the pure axial stress states of the piezoresistive beams could be easily achieved with position independence without tedious calculations. The measurement unit for the z-axis acceleration was innovatively designed as an interlocking proof mass structure to ensure a full Wheatstone bridge for sensitivity improvement. The pure axial stress state of the piezoresistive beams and low cross-sensitivity of all three units were verified by the finite element method (FEM). The triaxial accelerometer was fabricated and tested. Results showing extremely high sensitivities (x axis: 2.43 mV/g/5 V; y axis: 2.44 mv/g/5 V; z axis: 2.41 mV/g/5 V (without amplification by signal conditioning circuit)) and high natural frequencies (x/y axes: 11.4 kHz; z-axis: 13.2 kHz) were obtained. The approach of this paper makes it simple to design and obtain high-performance piezoresistive accelerometers.

Development of a High-Precision and Low Cross-Axis Sensitivity 3-D Accelerometer for Low-Frequency Vibration Measurement

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

Two-Dimensional Low-Frequency Optical Accelerometer With High Accuracy and Low Cross-Axis Sensitivity

Application of the Quartz-flexure Accelerometer to the Development of Ultra-low Frequency Vibration National Primary Standard Device

Accurate mechanical-optical theoretical model of cross-axis sensitivity of an interferometric micro-optomechanical accelerometer

Design and Simulation of a MEMS Fabry–Perot Accelerometer with Ultra-Low Cross-Axis Sensitivity

A Monolithic Three-Axis Accelerometer With Low Cross-Axis Sensitivity

New capacitive low-g triaxial accelerometer with low cross-axis sensitivity

Design, Fabrication, and Characterization of a High-Performance Monolithic Triaxial Piezoresistive High-g Accelerometer

Monolithically Integrated Triaxial High-Performance Micro Accelerometers with Position-Independent Pure Axial Stressed Piezoresistive Beams

Design and Modification of a High-Resolution Optical Interferometer Accelerometer

A High-Performance Monolithic Triaxial High-G Accelerometer

A MEMS Resonant Accelerometer for Low-Frequency Vibration Detection

Resonant MEMS Accelerometer with Low Cross-Axis Sensitivity—Optimized Based on BP and NSGA-II Algorithms

A High-Performance Multi-Beam Microaccelerometer for Vibration Monitoring in Intelligent Manufacturing Equipment

An Accelerometer with Integrative Intensity-Modulated Optical Encoder and Patterned Leaf Spring for Low-Frequency Vibration Monitoring

2 Ng/√hz-Resolution Optomechanical Accelerometer Employing a Three-Dimensional MEMS Interferometer.

A New High-Precision Micro-Accelerometer Based on Optomechanical System

A Low Cross-Axis Sensitivity Micro-Grating Accelerometer With Double-Layer Cantilever Beams

Design and Test of a Micromachined Resonant Accelerometer with High Scale Factor and Low Noise

A Resonant Accelerometer and Its Design