Abstract:By using the capacitive measurement principle, high-performance micromechanical accelerometers provide low noise and power consumption, cost efficiency, and reliability. Capacitive sensors based on changes in the gap between the electrodes, as a rule, require closed-loop control, which increases the level of complexity of the measurement circuit and increases power consumption. Capacitive sensitive elements with a change in the electrode overlap area have a good linearity of the capacitance versus displacement and a large measurement range, but they are more difficult to manufacture. This paper presents and investigates a model of a sensitive element of a sandwich design of a capacitive micromechanical accelerometer, the functioning of which is based on the use of a change in the relative dielectric constant of the dielectric of capacitors due to the introduction of a movable inertial mass between the electrodes of the capacitors, moving under the action of acceleration. As a result, there is a change in capacitance in the output measuring circuit. It is shown that the considered model is sensitive to acceleration and resistant to temperature changes, with low residual mechanical stress in the sensitive element. The modeling and calculations are performed using the Ansys and SolidWorks software. It is found that the movement of the moving mass along the axis of sensitivity X is more than five times the movement of the moving mass along the nonworking axes, and the change in the capacitance between the electrodes along the axis X is almost 2500 times more than the changes in capacitance between electrodes along the nonworking axes Z and Y . Calculations have shown that for all values of the acting acceleration (up to 30 g), the mechanical stress in the sensitive element is much less than the ultimate strength of silicon, equal to 440 MPa. It is found that variation of the temperature from –40 to 85°C leads to minor changes in capacitance along the working axis (0.0025–0.003 pF). This indicates the temperature stability of the investigated micromechanical accelerometer sensing element. The results of the analysis show that the developed and investigated model of the sensitive element of the sandwich design ensures the sensitivity of the micromechanical accelerometer and the stability of its parameters.

Design, Modeling and Analysis of Highly Reliable Capacitive Microaccelerometer Based on Circular Stepped-Plate and Small-Area Touch Mode

Design of Force-Balance Capacitive Accelerometer

Study of a Novel Micromachined Capacitive Accelerometer

Analysis of mechanical errors of planar capacitive sensor for two dimensional displacement measurement

Design Of The Closed-Loop Capacitive Micro-Accelerometer Based On Pspice

Studies on Self-Testable/Self-Calibratable Capacitive Microaccelerometer with Metal Structure and High Load Capacity

Design of a Micro Capacitive Acceleration Sensor Based on MEMS

Modeling the Sensitive Element of the Sandwich Construction of a Capacitive Micromechanical Accelerometer, Taking into Account the Change in the Dielectric Constant

The High-Efficiency Design Method for Capacitive MEMS Accelerometer

Structure Design And System Simulation Of 2-D Microaccelerometer

An Analytical Model for Studying the Structural Effects and Optimization of A Capacitive Tactile Sensor Array

A Capacitive Micro-Accelerometer Based on LTCC Laminates

Modeling and Analysis of A Flexible Capacitive Tactile Sensor Array for Normal Force Measurement

A Modified Analytical Model to Study the Sensing Performance of a Flexible Capacitive Tactile Sensor Array

Design and Fabrication of A High-Sensitive Capacitive Biaxial Microaccelerometer

A Novel Tunable Lateral Sensing Capacitive Silicon Micromachined Accelerometer with High Sensitivity

Modeling and Analysis of a SiC Microstructure-Based Capacitive Micro-Accelerometer

Design, Fabrication and Test of a Low Range Capacitive Accelerometer With Anti-Overload Characteristics

Design and experiment of high-overload capacitive micro-machined accelerometers

Novel Area-Changed Capacitive Methods for Simultaneous Displacement Transducing and Force Balance in a Nano-g MEMS Accelerometer

Design and Simulation of A Capacitive Biaxial Microaccelerometer