Abstract:Surface grafting polymerization of cast polypropylene (CPP)/acrylic acid( AA) system was studied with two-step method, which is a novel technique advantageous over traditional surface grafting polymerization initiated by UV. It consists of two steps. Firstly, dormant groups (semi-benzopinacol) were introduced on the CPP film under UV irradiation in the presence of benzophenone ( BP) solution; and then, AA was grafted on the substrate surface by thermoactivating polymerization. The principle is as following, after BP is excited with UV irradiation, it extracts the H atoms from CPP surface and is reduced into semipinacol free radicals, meanwhile macromolecular free radicals are produced on CPP film surface. Because of spatial hindrance originated from its aromatic group, it is difficult for semipinacol free radicals to perform coupling termination and so does the surface radical. If no monomer was available, these two kinds radicals will combine. When CPP film with dormant groups is heated in a monomer solution, the C-C bonds of surface semipinacol groups break into the surface free radicals and semipinacol free radicals. The surface radicals induced monomer to propagate, result in grafting chains; whileas the reactivity of semipinacole free radical is too low to initiate grafting polymerization. Consequently, this method has two advantages:high grafting efficiency and suited to more monomers which can not be used directly in traditional photografting polymerization. The results show that acetic anhydride is an ideal solvent for CPP/AA surface grafting system; grafting yield increases with the growth of photosensitizer and monomer concentration; and polymerization temperature has positive effect on grafting yield. The contact angle of grafted CPP film against water decreases with the increase of grafting yield. In addition, the grafted CPP-g-AA film was identified by FTIR spectra.

Surface Grafting Polymerization of Acrylonitrile Onto Polypropylene Film

Simultaneous Graft Polymerization of Polypropylene with Maleic Anhydride and Butyl Acrylate

Preparation of Temperature-Sensitive Polymer Films by Surface Photografting Techniques

A Facile Method for Grafting Polymerisation of Acrylonitrile onto LDPE Film with High Grafting Efficiency

Surface Photografting Polymerization of Binary Monomers Maleic Anhydride and n -Butyl Vinyl Ether on Polypropylene Film I. Effects of Principal Factors

Two-step surface grafting of acrylic acid on low density polyethylene(LDPE) film initiated by fluorenone

Study on Solid Phase Grafting of Acrylic Acid onto Polypropylene to Prepare Hydrophilic Polypropylene

Preparation and Surface Morphology of Pnipaam-Grafted Layers on Polypropylene Films

Grafting copolymerization of N,N-dimethyacrylaminoethylmethacrylate (DMAEMA) onto preirradiated polypropylene films

SURFACE PHOTOGRAFTING OF FUNCTIONAL MONOMERS INITIATED BY FLUORENONE ON LDPE FILMS

Vapour Phase Surface Graft Polymerization of Acrylonitrile Onto Poly(Ethylene Terephthalate) Film

STUDIES ON PHOTOGRAFTING OF TRIMETHYLOL PROPANE TRIACRYLATE ONTO THE SURFACE OF LDPE FILMS

Surface Graft Polymerization of Binary Monomers Maleic Anhydride/ n -Butyl Vinyl Ether on the Polypropylene Film via Two-Step Method

Surface Functionalization Of Polypropylene-Bearing Isocyanate Groups In Solid State And Their Cyclotrimerization With Diisocyanates

Study on Surface Grafting Polymerization of Cpp/Aa System with Two-Step Method

Grafting copolymerization of acrylamides onto preirradiated PP films

Study on the surface grafting of polypropylene fibers

Study on the Graft Reaction of Poly(propylene) Fiber with Acrylic Acid

Improvement of Antifogging of Low Density Polyethylene Film by Photografting Acrylic Acid

In-Situ Heterogenous Polymerization of Methyl Methacrylateonto Nanometer Calcium Carbonate Particles

Grafting Polymerization of Acrylic Acid Onto Preirradiated Polypropylene Fabric