Abstract:Surface grafting polymerization of cast polypropylene (CPP)/acrylic acid( AA) system was studied with two-step method, which is a novel technique advantageous over traditional surface grafting polymerization initiated by UV. It consists of two steps. Firstly, dormant groups (semi-benzopinacol) were introduced on the CPP film under UV irradiation in the presence of benzophenone ( BP) solution; and then, AA was grafted on the substrate surface by thermoactivating polymerization. The principle is as following, after BP is excited with UV irradiation, it extracts the H atoms from CPP surface and is reduced into semipinacol free radicals, meanwhile macromolecular free radicals are produced on CPP film surface. Because of spatial hindrance originated from its aromatic group, it is difficult for semipinacol free radicals to perform coupling termination and so does the surface radical. If no monomer was available, these two kinds radicals will combine. When CPP film with dormant groups is heated in a monomer solution, the C-C bonds of surface semipinacol groups break into the surface free radicals and semipinacol free radicals. The surface radicals induced monomer to propagate, result in grafting chains; whileas the reactivity of semipinacole free radical is too low to initiate grafting polymerization. Consequently, this method has two advantages:high grafting efficiency and suited to more monomers which can not be used directly in traditional photografting polymerization. The results show that acetic anhydride is an ideal solvent for CPP/AA surface grafting system; grafting yield increases with the growth of photosensitizer and monomer concentration; and polymerization temperature has positive effect on grafting yield. The contact angle of grafted CPP film against water decreases with the increase of grafting yield. In addition, the grafted CPP-g-AA film was identified by FTIR spectra.

Study on the surface grafting of polypropylene fibers

Simultaneous Graft Polymerization of Polypropylene with Maleic Anhydride and Butyl Acrylate

Surface Grafting Polymerization of Acrylonitrile Onto Polypropylene Film

Preparation of Temperature-Sensitive Polymer Films by Surface Photografting Techniques

Study on the Graft Reaction of Poly(propylene) Fiber with Acrylic Acid

Surface Functionalization Of Polypropylene-Bearing Isocyanate Groups In Solid State And Their Cyclotrimerization With Diisocyanates

Melt Grafting Of A Long-Chain Unsaturated Carboxylic Acid Onto Polypropylene

Study on Solid Phase Grafting of Acrylic Acid onto Polypropylene to Prepare Hydrophilic Polypropylene

Achieving highly effective non-biofouling performance for polypropylene membranes modified by UV-induced surface graft polymerization of two oppositely charged monomers.

Nondegradative Melt Functionalization of Polypropylene with Glycidyl Methacrylate

Influence Of Grafting Formulations And Extrusion Conditions On Properties Of Silane-Grafted Polypropylenes

Study on Surface Grafting Polymerization of Cpp/Aa System with Two-Step Method

Surface functionalization of polypropylene film via UV-induced photografting of N-vinylpyrrolidone/maleic anhydride binary monomers

Graft Modification of Chlorinated Polypropylene and Coating Performance Promotion for Polypropylene

STUDY OF GRAFTING NVP MONOMER ON POLYPROPYLENE NOV-WOVEN

Study of LDPE/NVP system surface grafting polymerization

Synthesis and Characterization of Solid-Phase Graft Copolymer of Polypropylene with Styrene and Maleic Anhydride

A Novel Method for Functionalization of Polypropylene with Oligomer of Glycidyl Methacrylate: Characterization of Copolymers

Influences Of Grafting Formulations And Processing Conditions On Properties Of Silane Grafted Moisture Crosslinked Polypropylenes

Research Review on Solid Phase Graft Modification of Polypropylene

Synthesis of multifunctional polypropylene via solid phase cografting and its grafting mechanism