Abstract:Using tert-butyl peroxy-2-ethyl hexanoate (TPRO) as initiator,the vinyl acetate (VAc) bulk grafting polymerization in the presence of polyethylene glycol (PEG) to get the PEG-g-PVAc was studied. The time evolution of polymerization rate,grafting ratio,grafting efficiency and molecular weight of the grafted copolymer were investigated respectively for various weight ratios of VAc to PEG. The results show that,with increasing VAc?PEG ratio,the polymerization rate and final conversion ratio are both enhanced,and an observable automatic acceleration phenomenon begins to appear. The overall reaction rate coefficient K increases with reaction time at higher VAc:PEG ratio,while a tendency of decrease of K with reaction time at lower VAc:PEG ratio was observed. At almost all VAc:PEG ratios,the grafting ratio was found to increase linearly with the conversion ratio,and the grafting efficiency keeps almost unchanged throughout the whole conversion. The grafting ratio is in proportion to VAc:PEG ratio,while the grafting efficiency is generally very high and can reach above 95% at low VAc?PEG ratio. Although the PEG grafted efficiency increases with both monomer consumption and rising VAc?PEG ratio,the overall PEG grafted efficiency is low,it indicates that a great amount of undrafted PEG exists. The phenomenon of high VAc grafting efficiency accompanying with low PEG grafted efficiency indicates that the 'Graft From' polymerization system may undergo a 'Graft Onto' mechanism. According to the definition,the PEG-g-PVAc number-average molecular weights were calculated,and the results show that the number-average molecular weights reduce at first with the increase of conversion ratio,and then approach to a constant; the higher the VAc?PEG ratio,the higher the number-average molecular weight. Via GPC analysis and PVAc universal calibration,the PDI (polydispersity index) of the grafted copolymer was determined to be between 1.5 ～ 2.5 and it aggrandizes with the increase of VAc concentration and conversion. It might be considered that,all these phenomena are related to the gel effect in the polymerization system.

Vapour Phase Surface Graft Polymerization of Acrylonitrile Onto Poly(Ethylene Terephthalate) Film

Kinetic Study of Vinyl Acetate Graft Polymerization on PEG

Study of barrier properties of poly(ethylene tetraphthalate/acrylonitrile) grafted films

A Facile Method for Grafting Polymerisation of Acrylonitrile onto LDPE Film with High Grafting Efficiency

Graft Copolymerization Of Methyl Acrylate Onto PET Initiated By Potassium Diperiodatonickelate (IV)

Surface Grafting Polymerization of Acrylonitrile Onto Polypropylene Film

PHOTOGRAFTING OF ACRYLIC ACID ONTO POLY(ETHYLENE TEREPHTHALATE) FILM

PHOTO-RESPONSIVE AZOPOLYMER GRAFTED PET FILMS AND THEIR ORIENTATION PROPERTIES

STUDIES ON PHOTOGRAFTING OF TRIMETHYLOL PROPANE TRIACRYLATE ONTO THE SURFACE OF LDPE FILMS

Photografting of Acrylic Acid on High Density Polyethylene Powder in Vapour Phase

Surface Photografting Polymerization of Binary Monomers Maleic Anhydride and n -Butyl Vinyl Ether on Polypropylene Film I. Effects of Principal Factors

Bulk surface photografting process and its applications. II. Principal factors affecting surface photografting

Surface Photografting Polymerization Of Trimethylolpropane Triacrylate Onto Ldpe Substrate In Tetrahydrofuran/Water Mixtures

Surface Photografting Polymerization of Vinyl Acetate (vac), Maleic Anhydride, and Their Charge Transfer Complex. II. VAc(2)

Polycondensation Reaction of P-Acetoxybenzoic Acid and Poly(Ethylene Terephthalate) and the Formation of Ether Bonds

Photo-Induced Graft Polymerization of Acrylamide on Polypropylene Membrane Surface in the Presence of Dibenzyl Trithiocarbonate

Polyacrylate Decorating Poly(ethylene terephthalate) (PET) Film Surface for Boosting Oxygen Barrier Property

Preparation and Surface Morphology of Pnipaam-Grafted Layers on Polypropylene Films

Surface Photograft Polymerization of Vinyl Acetate on Low Density Polyethylene Film. Effects of Solvent

Photografting Modification of PET Nucleopore Membranes

MMA/DVB emulsion surface graft polymerization initiated by UV light.