Abstract:Microstructure and texture of electrodeposited Cu micro-cylinders in the blind hole play a vitally important role in the electrical and mechanical properties of the three-dimensional (3-D) IC (integrated circuit)/Si integrations. In this paper, a new commercial additive system, which is specifically developed for the high-aspect-ratio through-silicon-via (TSV) filling, was used to electrodeposit Cu in the blind holes. The microstructure of electrodeposited Cu micro-cylinder in the blind hole with a diameter of 40 mu m and a depth of 140 mu m was investigated by electron back-scattered diffraction (EBSD) technique. Grain size distribution of the Cu micro-cylinder in the blind hole differed from the bottom to the top. The grain boundaries contained a high fraction of Sigma 3 CSL (coincident site lattice) boundaries. It has been reported that the Cu overburden film on the surface of the blind hole influenced the crystallographic orientation of Cu grains inside the damascene trench. So the effects of the current density and additive concentration on the crystal structure of the overburden Cu film were also studied in this study. The experimental results indicated that the preferred orientation of the Cu overburden film changed from {111} to {220} when the current density increased from 2 to 80 mA cm(-2). However, the effect of additives on the crystal structure of the Cu overburden film was dependent on the crystal structure of the seed layer. Copyright (C) 2016, The editorial office of Journal of Materials Science & Technology. Published by Elsevier Limited. All rights reserved.

Microstructure and Hardness of Electrodeposited Copper Microcylinders in Through-Silicon Via by Direct Current Power

Effect of cryogenic impact deformation and subsequent annealing on microstructure and microhardness of pure copper

Effect of current density on microstructure and mechanical property of Cu micro-cylinders electrodeposited in through silicon vias

Deep Silicon Macropores Filled with Copper by Electrodeposition

High Strength and High Ductility Copper Obtained by Topologically Controlled Planar Heterogeneous Structures

Microstructures of Copper Electroplated Through-Silicon Via Characterized by Electron Backscattering Diffraction Technique

Microstructure of Electrodeposited Cu Micro-cylinders in High-Aspect-Ratio Blind Holes and Crystallographic Texture of the Cu Overburden Film

Electrodeposition of (111)-oriented and nanotwin-doped nanocrystalline Cu with ultrahigh strength for 3D IC application

Ultra-high flatness and conductivity of copper electrodeposits obtained by nano-twinned/fine-grained double layer electrodeposition

Microstructural effects of copper deposits on direct bonding for 3D IC integration

Electroless Copper Deposition for Ultralarge-Scale Integration

Study On Physical Properties Of Ultrasonic-Assisted Copper Electrodeposition In Through Silicon Via

Microplasma Direct Writing of a Copper Thin Film in the Atmospheric Condition with a Novel Copper Powder Electrode

Study Of Mechanical Properties Of Cu Through-Silicon-Vias (Tsv) Specimen Using Electrodeposition Bath

Research on micro structure using EDM deposition

Electrodeposition: Small 20/2009

Surface Atom Migration-involved Two-dimensional Nucleation and Growth of Nanotwinned Copper in DC Electrodeposition

Experimental Analysis Of The Co-Deposition Of Metal Cu And Nano-Sized Sic Particles With Ctab In Micro Via Filling

In Situ Study of Copper Electrodeposition on A Single Carbon Fiber

Influence of annealing conditions on the mechanical and microstructural behavior of electroplated Cu-TSV

Investigate the Microstructure Changes in Cu Through-Silicon Vias (tsvs) under Thermal Process