Abstract:Two sequences of tension–fatigue and fatigue–tension tests were performed on copper polycrystal sheet, with a mean grain size of 32 μm. For the angle between the two successive loading directions, two typical values (0 and 45°) have been chosen. The effect of strain path change on subsequent initial work hardening rate and saturation stress in tension–fatigue, as well as the effect of strain path change on subsequent yield and flow behaviour in fatigue–tension have been investigated. The strain rate for the tension tests was 5×10−3 s−1, while the fatigue tests were performed under constant plastic strain amplitude control with different values of amplitudes (εpl=6×10−4, 1.5×10−3, 3×10−3). Slip morphology and dislocation microstructure were observed by optical and transmission electron microscopy (TEM) after mechanical tests. Under these conditions, in the case of fatigue–tension, it was found that fatigues prestraining influences the subsequent yield and flow behaviour in tension. However, the subsequent mechanical behaviour of samples seems only to be affected by the magnitude of strain path change (namely, the angle between the two successive loading directions), and not by the value of the plastic strain amplitude of the preceding fatigue tests. In the case of tension–fatigue, the strain amount of preloading in tension obviously affects the initial cyclic hardening rate, while it has almost no effect on the saturation stress of subsequent fatigue tests, irrespective of the value of the angle between the two successive loading directions. The occurrence of microbands in the saturation fatigue dislocation structures of samples prestrained in tension implies that fatigue is a more effective loading mode than tension, in causing intense glide on the activated slip systems. The correlation between mechanical properties and microstructural observations is discussed.

Analysis of Stored Energy in Cold-Rolled Copper Using Bulk and Microstructure-Based Techniques

Stored Energy, Microstructure, and Flow Stress of Deformed Metals

Stored Energy in Nickel Cold Rolled to Large Strains, Measured by Calorimetry and Evaluated from the Microstructure

Microstructural-Based Measurement of Local Stored Energy Variations in Deformed Metals

The Stored Energy in Processed Cu–0.4 Wt.%cr–0.12 Wt.%zr–0.02 Wt.%si–0.05 Wt.%mg

In situ XRD studies of the process dynamics during annealing in cold rolled copper

Relating Residual Stress and Microstructure to Mechanical and Giant Magneto-Impedance Properties in Cold-Drawn Co-based Amorphous Microwires

Stored Energy and Structure in Top-Down Processed Nanostructured Metals

Neutron diffraction method for stored energy measurement in interstitial free steel

Strain localization and ductile fracture mechanism of micro/mesoscale deformation in ultrafine-grained pure copper

Experimental Study on Pure Copper Subjected to Different Severe Plastic Deformation Modes

An investigation of slip transmission during uniaxial tensile deformation of a coarse-grained copper via EBSD characterization and crystal plasticity modelling

Stored energy of a severely deformed interstitial free steel

Microstructure and Stored Energy Evolutions During Rolling of Cu60Zr20Ti20 Bulk Metallic Glass

Microstructural evolution and strength of copper during cold rolling to large strain

Effect of cryo-rolling on mechanical properties and microstructure of pure copper

New method for analyzing recrystallization kinetics of deformed metal by differential scanning calorimeter

Measurement of Orientation Dependent Stored Energy of Deformation on A Local Scale

Microscopic Heterogeneity of Plastic Strain and Lattice Rotation in Partially Recrystallized Copper Polycrystals

Microstructure and Properties of Cold Rolled Cu_(88)Fe_(12) Alloys

Mechanical Behaviour and the Evolution of the Dislocation Structure of Copper Polycrystal Deformed under Fatigue–tension and Tension–fatigue Sequential Strain Paths