Abstract:Recent progresses in atomistic simulations of plastic deformation in nano-scale metallic crystals are presented. Attention is devoted to adjusting the interatomic potential parameters with the objective of gaining fundamental insight into the crystal defect processes in fcc metals. An initial defect is utilized in the molecular statics model to trigger plasticity in a controlled manner. A parametric study is performed by varying the atomic interaction range used in the copper model, such that dislocation slip behavior and/or phase transformation can first be observed without the influence of an unstable surface state of the specimen. We focus on tensile loading along a low-symmetry orientation where single slip prevails upon yielding. When the interaction distance is small, dislocation slip is seen to be the dominant deformation mechanism. A slight increase in the interaction range results in phase transition from the fcc structure to a bcc structure. Re-orientation of the bcc lattice also occurs at later stages of the deformation via a twinning operation. The phase transition mechanism is further enhanced if the nanowire is attached to a flat substrate parallel to the initial close-packed plane. When the atomic interaction range is increased further, the effect of surface stress becomes increasingly important. Plastic yielding occurs in the form of partial slip which creates a stacking fault in the slip plane. The initial point defect plays a less significant role and phase transition during deformation is suppressed. Detailed mechanisms of these atomistic features, as well as their implications to computational simulations of plastic deformation in metallic nanostructures, will be discussed.

Stored Energy and Structure in Top-Down Processed Nanostructured Metals

Achieving High Strength and High Ductility in Nanostructured Metals: Experiment and Modelling

Stored Energy, Microstructure, and Flow Stress of Deformed Metals

Atomistic perspective on in situ nanomechanics

In Situ TEM Study of Pulse-Enhanced Plasticity of Monatomic Metallic Glasses

Analysis of Stored Energy in Cold-Rolled Copper Using Bulk and Microstructure-Based Techniques

In situ TEM study of microplasticity and Bauschinger effect in nanocrystalline metals

Characterization and Influence of Deformation Microstructure Heterogeneity on Recrystallization

Microstructural-Based Measurement of Local Stored Energy Variations in Deformed Metals

Stored Energy in Nickel Cold Rolled to Large Strains, Measured by Calorimetry and Evaluated from the Microstructure

Local Deformation Mechanisms in Metal Systems with a Tailored Grain Size Distribution

Heterogeneous local plastic deformation of interstitial free steel revealed using in-situ tensile testing and high angular resolution electron backscatter diffraction

Neutron diffraction method for stored energy measurement in interstitial free steel

Measurement of Orientation Dependent Stored Energy of Deformation on A Local Scale

Characterization of heterogeneity in nanometals deformed to large plastic strains

Nanomechanical Characterization of Metallic Materials

New Insight for Mechanical Properties of Metals Processed by Severe Plastic Deformation

Effect of second-phase precipitates on deformation microstructure in AA2024 (Al–Cu–Mg): dislocation substructures and stored energy

Quantification of Heterogeneity in Microstructural Refinement in Metals and Alloys Deformed to High Plastic Strains.

Pramatic Atomistic Analysis of Nano-scale Metal Plasticity

EBSD-Based Techniques for Characterization of Microstructural Restoration Processes During Annealing of Metals Deformed to Large Plastic Strains