Abstract:Severe plastic deformation (SPD) techniques have attracted significant attention in the last two decades due to its capacity of producing bulk ultra-fine grained (UFG) or nanostructured materials, by imposing very high plastic strain. Equal channel angular pressing (ECAP), or equal channel angular extrusion (ECAE), is one of the most widely used SPD techniques. During ECAP, a sample is pressed through a die which consists of two channels with equal cross-section intersecting at an angle varying from 60 degrees to 150 degrees. Since the cross-section geometry of the sample remains nearly unchanged, the materials can be deformed to a very high strain by repeating the process. The deformation mechanism of ECAP is very complicated and it is dependent on the die geometry and material properties. It has been assumed as simple shear on the intersecting plane of two channels at ideal conditions, such as frictionless, perfectly plastic material and very sharp outer corner. However, from the view of texture evolutions, many experimental results have revealed the deviation from the ideal simple shear. Therefore, an insight into the deformation mechanism and orientation changes in the real ECAP case is still essential. In the present work, a comprehensive study based on the crystal plasticity finite element model (CPFEM) has been conducted to investigate the stress state, plastic strain, required load and crystallographic orientation development history of aluminum single crystals subjected to ECAP. The influence factors such as ECAP die geometry, frictional conditions and initial crystallographic orientations have been studied in detail.

EBSD-Based Techniques for Characterization of Microstructural Restoration Processes During Annealing of Metals Deformed to Large Plastic Strains

Microstructural Parameter-Based Characterization of Annealing Behaviour in Metals Deformed to High Strains

Characterization and Influence of Deformation Microstructure Heterogeneity on Recrystallization

Coupling Of Local Texture And Microstructure Evolution During Restoration Processes In Aluminum Deformed To Large Strains

Quantification of Heterogeneity in Microstructural Refinement in Metals and Alloys Deformed to High Plastic Strains.

An Insight into the Deformation and Orientation Development of Severely Plastic Deformed Aluminum

Quantification of Annealed Microstructures in ARB Processed Aluminum

EBSP Study of the Annealing Behavior of Aluminum Deformed by Equal Channel Angular Processing

Mechanical Behavior, Deformation Mechanism and Microstructure Evolutions of Ultrafine-Grained Al During Recovery Via Annealing

Thermal Restoration Kinetics and Microstructural Evolution of an Mg-RE Alloy During Annealing by Quasi-in-situ Observation

Orientation Changes During Annealing of Nanotructured Aluminium

Annealing behaviour and mechanical properties of severely deformed interstitial free steel

EBSD Study of Microstructure Evolution of Ferritic Stainless Steel During Cold Rolling and Annealing

Stored Energy and Annealing Behavior of Heavily Deformed Aluminium

EBSD Analysis of Deformed and Partially Recrystallized Microstructures in ECAE-Processed Copper

Structural Coarsening During Annealing of an Aluminum Plate Heavily Deformed Using ECAE

Microstructure and Mechanical Properties of Nanostructured Metals Produced by High Strain Deformation

Annealing Behavior of Aluminium Deformed by Equal Channel Angular Pressing

Structural Refinement and Coarsening in Deformed Metals

Large Strain Deformation and Annealing of Aluminium

Microscopic Heterogeneity of Plastic Strain and Lattice Rotation in Partially Recrystallized Copper Polycrystals