Abstract:Scanning probe microscopy was used to simultaneously determine the molecular chain structure and intrinsic mechanical properties, including anisotropic elastic modulus and friction, for lamellae of highly oriented high-density polyethylene (HDPE) obtained by the melt-drawn method. The molecular-scale image of the highly oriented lamellae by friction force microscopy (FFM) clearly shows that the molecular chains are aligned parallel to the drawing direction, and the periodicities along and perpendicular to the drawing direction are 0.26 and 0.50 nm, respectively. The results indicate that the exposed planes of the lamellae resulting from the melt-drawn method are (200), which is consistent with results of transmission electron microscopy and electron diffraction. Because of the high degree of anisotropy in the sample, coming from alignment of the molecular chains along the drawing direction, the measured friction force, F, determined by FFM is strongly dependent on the angle, theta, between the scanning direction and the chain axis. The force increases as theta is increased from 0 degrees (i.e., parallel to the chain axis) to 90 degrees (i.e., perpendicular to the chain axis). The structural anisotropy was also found to strongly influence the measurements of the transverse chain modulus of the polymer by the nanoindentation technique. The measured value of 13.8 GPa with transverse modulus was larger than the value 4.3 GPa determined by wide-angle X-ray diffraction, which we attributed to anisotropic deformation of the lamellae during nanoindentation measurements that was not accounted for by the elastic treatment we adopted from Oliver and Pharr. The present approach using scanning probe microscopy has the advantage that direct correlations between the nanostructure, nanotribology, and nanomechanical properties of oriented samples can be determined simultaneously and simply.

Measurement of Orientation Dependent Stored Energy of Deformation on A Local Scale

Microstructural-Based Measurement of Local Stored Energy Variations in Deformed Metals

Stored Energy, Microstructure, and Flow Stress of Deformed Metals

Investigation of Medium to High Strain Deformation Microstructures Using an Automated Electron Backscattering Pattern (EBSP) System

Local measurements of stored energy: Microstructural and stereological considerations

Characterization and Influence of Deformation Microstructure Heterogeneity on Recrystallization

High Strain Gradient Plasticity Associated with Wedge Indentation into Face-Centered Cubic Single Crystals: Geometrically Necessary Dislocation Densities

Nanostructure and Mechanical Measurement of Highly Oriented Lamellae of Melt-Drawn HDPE by Scanning Probe Microscopy

Local Texture Evolution during Rolling Deformation of Single Crystals of {100} Orientation

Elastic strain mapping of plastically deformed materials by TEM

Analysis of Stress and Deformation States in Wedge Indented Face-Centered Cubic Single Crystals

Investigation of Grain Subdivision at Very Low Plastic Strains in A Magnesium Alloy

Stored Energy and Structure in Top-Down Processed Nanostructured Metals

Analysis of Stored Energy in Cold-Rolled Copper Using Bulk and Microstructure-Based Techniques

Orientation-Dependent Mechanical Behaviors of BCC-Fe in Light of the Thermo-Kinetic Synergy of Plastic Deformation

Neutron diffraction method for stored energy measurement in interstitial free steel

Determining dislocation cell sizes for high-strain deformation microstructures using the EBSP technique

A Large Deformation Atomistic Study Examining Crystal Orientation Effects on the Stress–strain Relationship

Characterisation of Orientation Noise during EBSP Investigation of Deformed Samples

A Multiscale Investigation of the Physical Origins of Tension--Compression Asymmetry in Crystals and their Implications for Cyclic Behavior

Processing and Interpretation of EBSD Data Gathered from Plastically Deformed Metals