Abstract:The thermal reliability of two different high-power insulated gate bipolar transistor (IGBT) modules was studied under both conduction and switching regimes by experimental and numerical approaches. Indeed, the reliability of semiconductor devices is tightly linked to the junction temperatures reached in the IGBT, which is a function of the diode chips present in such devices and its operating condition. However, measurements of the semiconductor temperatures are often difficult to be done, thus requiring modeling and simulation tools to accurately evaluate the instantaneous temperature under different thermal loads. For this reason, a transient 3D heat transfer numerical model of two different IGBT power devices was proposed using the Finite Element Method, assuming that heat is dissipated on the IGBT by natural convection and radiation. These simulations were validated with experimental measurements, obtained through infrared thermography, performed for the IGBT modules either opened or enclosed, varying the heat source, the module orientation and under conduction or switching regime. For the switching regime, power losses due to the gate-closing and gate-opening transitions between conducting and non-conducting states were taken into consideration. The heat losses were modeled assuming the time-dependent heat dissipation obtained by previous electrical simulations, and it was compared with time-averaged heat source solutions. Results showed that averaging the heat source can significantly reduce the computational time, allowing quick design explorations. Overall, the numerical model led to deviations of less than 16% over the transient heating and at steady-state. Finally, the impact of a heat sink attached to the IGBT was studied, demonstrating that the proposed model can be used for accurate and quick investigations of potential failures and for the development of more efficient IGBT devices.

Investigation of Si IGBT Operation at 200 $\,{}^\circ$ C for Traction Applications

Investigation of Si IGBT operation at 200 °C for traction application

Investigation of Si IGBT Operation at 200 degrees C for Traction Application

Investigation on Hot-Carrier-induced Degradation of SOI NLIGBT.

Comparative Study on Reliability and Application Features of SiC MOSFET

An Experimental And Numerical Investigation Of Igbt Blocking Characteristics

Si IGBT Phase-Leg Module Packaging and Cooling Design for Operation at 200 °c in Hybrid Electrical Vehicle Applications

A SiC-Based Liquid-Cooled Electric Vehicle Traction Inverter Operating at High Ambient Temperature

Dynamic Performance of 6.5kV/400A SiC MOSFET Module and its Gate Driver

Short Circuit Capability and High Temperature Channel Mobility of SiC MOSFETs

Characterising Trench Igbts in Resonant Switching Using Single Ended and Half-Bridge Application Circuits

Study of IGBTs Reliability under Coupled Electrical–Thermal Environment

Heat Dissipation Characteristics of IGBT Module Based on Flow-Solid Coupling

Design and Characterization of 10 kV High Voltage 4H-SiC p-Channel IGBTs with Low VF

Temperature Dependence of Dynamic Performance Characterization of 1.2-kV SiC Power mosfets Compared With Si IGBTs for Wide Temperature Applications

Investigations of P-Shielded SiC Trench IGBT with Considerations on IE Effect, Oxide Protection and Dynamic Degradation

Characterization of 1.2 Kv 4H-Sic Power Mosfets and Si Igbts at Cryogenic and High Temperatures

Thermal and electrical evaluation of insulated gate bipolar transistor (IGBT) power modules

A High Temperature Gate Drive Circuit for SiC MOSFET

Thermal Management on IGBT Power Electronic Devices and Modules