Abstract:This paper reports a novel MEMS accelerometer whose effective stiffness can be adjusted flexibly and even tuned to almost zero by using the electrostatic softening effect of two parallel plate capacitors: the comb-finger capacitor and the triangular capacitor. When applied to a biased voltage, the comb-finger capacitor provides a relatively large and nonlinear negative stiffness in the gap-varying direction, while the triangular capacitor produces a small yet linear negative stiffness in the area-varying direction. The proposed accelerometer is fabricated by using a standard silicon-on-glass manufacturing process and controlled by a customized digital circuit. An analytical model based on the pull-in dynamics as a result of the stiffness tuning is developed and simulated to investigate the dynamic behavior of the nonlinear accelerometer system. The proportion integral differential controller is utilized to improve the performance of the accelerometer while maintaining the stability of the closed-loop system operating with extremely low effective stiffness. The experimental results indicate that a two-fold increase of the sensitivity, a 30% reduction of Allan deviation bias instability, and a 20% reduction of Allan velocity random walk are achieved for the open-loop accelerometer system. A 75% decrease of the standard deviation bias instability and nearly two orders of magnitude improvement of the noise floor at 1 Hz for the closed-loop accelerometer system are realized when the effective stiffness is reduced to almost zero.

Compact Electrode Design for an In-Plane Accelerometer on SOI with Refilled Isolation Trench

Compact electrode design for in-plane accelerometer on SOI with refilled isolation trench

An In-Plane Low-Noise Accelerometer Fabricated with an Improved Process Flow

A Three-Axis SOI Accelerometer Sensing with Both In-Plane and Vertical Comb Electrodes

A Stiffness-Tunable MEMS Accelerometer

A Novel Soi Z-axis Accelerometer with Gap Closing Differential Sensing Electrodes

Three-Axis Capacitive SOI Accelerometer Using Combination of In-Plane and Vertical Comb Electrodes

Challenges and Solutions for Fabricating Isolation Trenches for High Aspect Ratio Sensors

Implementation of A Gap-Closing Differential Capacitive Sensing Z-Axis Accelerometer on an Soi Wafer

A novel SOI-based single proof-mass 3-axis accelerometer with gap-closing differential capacitive electrodes in all sensing directions

A Novel Cmos Out-Of-Plane Accelerometer with Fully Differential Gap-Closing Capacitance Sensing Electrodes

Fabrication Challenges and Test Structures for High-Aspect-ratio SOI MEMS Devices with Refilled Electrical Isolation Trenches

A MEMS Sandwich Differential Capacitive Silicon-on-insulator Accelerometer

A novel capacitive accelerometer with an eight-beam-mass structure by self-stop anisotropic etching of (1 0 0) silicon

A two degrees of freedom comb capacitive-type accelerometer with low cross-axis sensitivity

3-axis Capacitive Low-Gravity MEMS Accelerometer with Zero Cross-Axis Sensitivity in a Commercial Process

Design and Fabrication Research on a Capacitive Accelerometer

Silicon-On-Insulator Out-Of-Plane Electrostatic Actuator with in Situ Capacitive Position Sensing

A Novel Out-Of-Plane Accelerometer with Fully-Differential Sensing Circuit and Sub-Micron Gap

A silicon-on-glass Z-axis accelerometer with vertical sensing comb capacitors.

A poly-Si based 2-axis differential capacitive-sensing accelerometer