Abstract:The ultrahigh static displacement-acceleration sensitivity of a mechanical sensing chip is essential primarily for an ultra-sensitive accelerometer. In this paper, an optimal design to implement to a single-axis MOEMS accelerometer consisting of a grating interferometry cavity and a micromachined sensing chip is presented. The micromachined sensing chip is composed of a proof mass along with its mechanical cantilever suspension and substrate. The dimensional parameters of the sensing chip, including the length, width, thickness and position of the cantilevers are evaluated and optimized both analytically and by finite-element-method (FEM) simulation to yield an unprecedented acceleration-displacement sensitivity. Compared with one of the most sensitive single-axis MOEMS accelerometers reported in the literature, the optimal mechanical design can yield a profound sensitivity improvement with an equal footprint area, specifically, 200% improvement in displacement-acceleration sensitivity with moderate resonant frequency and dynamic range. The modified design was microfabricated, packaged with the grating interferometry cavity and tested. The experimental results demonstrate that the MOEMS accelerometer with modified design can achieve the acceleration-displacement sensitivity of about 150 mu m/g and acceleration sensitivity of greater than 1500V/g, which validates the effectiveness of the optimal design.

A Novel Out-Of-Plane Accelerometer with Fully-Differential Sensing Circuit and Sub-Micron Gap

A Novel Cmos Out-Of-Plane Accelerometer with Fully Differential Gap-Closing Capacitance Sensing Electrodes

A Novel Soi Z-axis Accelerometer with Gap Closing Differential Sensing Electrodes

Study of a Novel Micromachined Capacitive Accelerometer

An In-Plane Low-Noise Accelerometer Fabricated with an Improved Process Flow

Implementation of A Gap-Closing Differential Capacitive Sensing Z-Axis Accelerometer on an Soi Wafer

A Monolithic 3d Fully-Differential Cmos Accelerometer

A CMOS-MEMS accelerometer with tri-axis sensing electrodes arrays

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

Monolithic Integrated Micro-Opto-Electromechanical Accelerometer Based on Michelson Interferometer Structure

A Three-Axis CMOS-MEMS Accelerometer Structure With Vertically Integrated Fully Differential Sensing Electrodes

Design And Implementation Of A Novel Cmos-Mems Single Proof-Mass Tri-Axis Accelerometer

Micro-machined Resonant Out-of-plane Accelerometer with a Differential Structure Fabricated by Silicon-on-insulator–mems Technology

A novel SOI-based single proof-mass 3-axis accelerometer with gap-closing differential capacitive electrodes in all sensing directions

A Novel Micro-Machined Out-of-Plane Resonant Accelerometer with Differential Structure of Different-Height Resonant Beams

Design of a Novel Low Cross-Axis Sensitivity Micro-Gravity Sandwich Capacitance Accelerometer.

Implementation Of Fully-Differential Capacitance Sensing Accelerometer Using Glass Proof-Mass With Si-Vias

A Sub-µg Bias-Instability MEMS Oscillating Accelerometer with an Ultra-Low-Noise Read-Out Circuit in CMOS

A novel out-of-plane MEMS tunneling accelerometer

Design and Application of a Metal Wet-Etching Post-Process for the Improvement of CMOS-MEMS Capacitive Sensors

A Novel Cmos Mems Accelerometer With Four Sensing Finger Arrays