Abstract:With the development of integrated circuit towards the characteristics of the low-power consumption, miniaturization and high integration, three-dimensional integration technology based on Through-Silicon Via (TSV) comes into being. However, the thermal accumulation caused by the maximum stack density and the thermal stress caused by the mismatched thermal expansion coefficient between TSV surrounding materials will lead to the reliability problems such as circuit function failure and device performance drift. In this paper, the heat dissipation performance and thermal-mechanical reliability of TSV array in 2.5D silicon interposer were studied when the operation temperature is increased from 20°C to 100°C. Firstly, the influences of the geometrical parameters, such as the through hole radius, depth to width ratio, insulation thickness and TSV spacing, on thermal-mechanical reliability were analyzed for single TSV, paired TSV and 3*3 TSV array structures. Secondly, a configuration of TSV regular hexagonal array in silicon interposer is proposed to improve its heat dissipation performance.Our simulation results disclose that the stress is mainly concentrated at the junction where SiO2 layer deviates to copper and silicon substrate deviates to SiO2, which indicates the SiO2 layer is most prone to fracture. The through hole radius should be designed as small as possible to reduce the thermal stress, and a thicker SiO2 insulation layer thickness will induce the better thermal-mechanical stability of TSV. The optimized TSV's depth to width ratio should be set above 5 with the simultaneous consideration of the stress for silicon substrate, insulating layer, filled copper. For multiple TSVs, the spacing should be greater than twice the diameter to eliminate the influence of thermal stress between TSVs. In addition, in the case of the same spacing, the equivalent unit temperature of TSV regular hexagonal array distribution is 2.9°C lower than that of conventional matrix array distribution. The analysis and design of TSV array in 2.5D silicon interposer is promising to offer guideline to the future advanced package development.

Design, Simulation, And Process Development For 2.5d Tsv Interposer For High Performance Processer Packaging

Process Development of A New Tgv Interposer for Wafer Level Package of Inertial Mems Device

Development of a BGA Package Based on Si Interposer with Through Silicon Via

A New 2.5d Tsv Package Assembly Approach

A 3D Integration Testing Vehicle with TSV Interconnects

Development of high performance 2.5D packaging using glass interposer with through glass vias

Design and fabrication of a TSV interposer for SRAM integration

Process Development of Thick Si Interposer for 2.5d Integration of Rf Mems Devices

Thermal-Mechanical Analysis of TSV Array in 2.5D Silicon Interposer

Fabrication, Characterization, and Simulation of a Low-Cost TSV Integration Without Front-Side CMP Process

3D interconnection process development and integration with low stress TSV

Process Development and Characterization for Integrating Microchannel into Tsv Interposer

Thermal Performance of 2.5D Packaging with the Through Glass Via (TGV) Interposer

Fabrication of Microchannel Embedded Tsv Interposer and Its Influence on Tsv'S Electrical Parameters

Advanced 3D Through-Si-Via and Solder Bumping Technology: A Review

Copper-Based TSV: Interposer

Simulation and Optimization of 3D Heterogeneous Integration of Inertial Micro-System

Double-Shielded Interposer with Highly Doped Layers for High-Speed Signal Propagation

Through silicon via copper electrodeposition for 3D integration

Interposer Fabrication with Annular Copper Tsv and Multi-Layered Redistribution Layer

Thermal analysis and heat dissipation optimization of 3D packaging with TSV interposer