Abstract:We report here a detailed characterization of the surface chemical states and morphology of polyimide (PI) films following modifications by plasma treatment and electroless copper deposition. NH3 and Ar plasma treatments have been successfully used to achieve morphological and chemical modification of the PI surface so that electroless copper plating can occur. The adhesion strength of the electroless copper to the PI surface was measured and correlated with the plasma-induced chemical and physical modifications of the PI surface. The NH3 plasma causes primarily chemical changes to the PI surface through creation of nitrogen moieties (i.e., –N =C< ) on the surface. The Ar plasma treatment brings about mainly physical changes to the surface (i.e., surface roughening). The combined-plasma treatment (Ar plasma followed by NH3 plasma) combines the desirable chemical and physical effects of each treatment, yielding a PI surface with higher roughness for physical anchoring of the copper and surface bonding sites (nitrogen and oxygen sites). During the electroless copper surface activation step with tin chloride and palladium chloride, tin bonds mainly with the oxygen on the surface, whereas palladium reacts with tin chloride as well as with the surface nitrogen. A direct relationship has been observed between surface palladium concentration and the abundance of the –N =C< sites on the surface. This suggests that the nitrogen radicals created during the NH3 plasma are incorporated into the surface and serve as bonding sites for the palladium. In the subsequent electroless Cu deposition, there was a direct correlation between the palladium surface concentration and Cu coverage. The adhesion strength of the electroless copper to the PI correlated well to the surface modifications and plasma treatment conditions. For the first time, a specific bonding configuration on the PI surface is shown to promote adsorption of palladium, which in turn promotes covalent bonding with Cu. The relative importance of surface roughness and chemical bonding on the adhesion strength is discussed.

Study of Adhesion Strength of Electroplated Copper to Polyimide Using Different Types of Tie Layers

Adhesion Properties of Electroplating Process Between Polyimide and Metal Layer for Polymer/Metal Hybrid Bonding

Diffusion and Adhesion Properties of Cu Films on Polyimide Substrates

Adhesive properties of deposited Cu films on colorless polyimide using high power impulse magnetron sputtering system

Grafting Amino Groups onto Polyimide Films in Flexible Copper-Clad Laminates Using Helicon Plasma

Plasma Treatment and Surface Analysis of Polyimide Films for Electroless Copper Buildup Process

Studies of Polyimide/copper Interface and Its Improvement by a Two‐component Primer

Surface Modification of Copper for Adhesion Promotion by Polybenzimidazole

Study on Aging Effect of Adhesion Strength Between Polyimide Film and Copper Layer

Plasma surface pretreatment to improve interfacial adhesion strengths of sputtered Cu on polyimide film

Electroless Plating of Copper on Fluorinated Polyimide Films Modified by Plasma Graft Copolymerization and UV‐induced Graft Copolymerization with 4‐Vinylpyridine

Enhancing the bond strength of magnetron-sputtered copper layers on polyimide and polyether ether ketone surfaces through surface modification

Super-high interface adhesion through silver/polyimide heterojunction

Photocatalytic Surface Modification of PI Film for Electroless Copper Plating

Effect of surface roughness on the adhesion properties of Cu/Cr films on polyimide substrate treated by inductively coupled oxygen plasma

Mechanism analysis of PI/PEEK interface bonding properties enhanced by atmospheric plasma treatment: Experiment and DFT calculation

Adhesion and Transparency Enhancement between Flexible Polyimide-PDMS Copolymerized Film and Copper Foil for LED Transparent Screen

Copper Metallization on the Surface-Modified Polyimide Films by Electroless Plating Method

Effect of Silver Nitrate on Electroless Copper Plating on the Surface of Polyimide Film

Effect of heat treatment on the peel strength of two kinds of Cu film

Effect of High-Frequency and High-Density Current on Adhesive Strength of Copper Thin Film