Abstract:The simultaneous increase in strength and plasticity of aluminum and its alloys at cryogenic temperatures has been shown in previous research, but the deformation mechanism was still unclear. Therefore, the purpose of this investigation was to reveal the relationship between slip behavior and mechanical response at low temperatures. A quasi-in situ scanning electron microscope was used to observe the evolution of slip bands in the selected aluminum single crystals with two typical orientations at 25 °C, -100 °C, and -180 °C. The results showed that irrespective of orientation, the density of the slip plane was increased with the decline in temperature, which inhibited slip localization and significantly improved plasticity and work hardening. In detail, at RT, the slip bands were widening until the micro-cracks were generated, causing early failure during deformation. When the temperature was decreased to -180 °C, the slip plane density was increased, and the deformation was more homogenous. Moreover, the slip mode was influenced by orientation and temperature. In particular, a single slip system was activated in the sample with the [112] orientation at all the temperatures investigated. Multiple slip systems were found to activate at 25 °C and -100 °C, and only the primary slip system was activated in the sample with [114] orientation at -180 °C. These findings deepen the understanding of slip behavior at cryogenic temperatures, providing new insights into the deformation mechanism of aluminum and its alloys.

The cryogenic mechanical properties of translucent alumina

Mechanical and Thermal Properties of 99% and 92% Alumina at Cryogenic Temperatures

Research of Mechanical and Thermal Properties of Al2O3 at Cryogenic Temperatures

Failure Mechanisms of Al2O3 with Different Glass Phase Content at Cryogenic Temperatures

Mechanical and thermal properties of Al 2O 3-ZrO 2 composite ceramics at cryogenic temperatures

Fracture mechanism of a fracture-resistant CNT/alumina nanocomposite at cryogenic temperature

Enhanced Mechanical Properties of SiC/Al Composites at Cryogenic Temperatures

Strengthening Mechanism of Aluminum Nitride Ceramics from 293 to 77 K

Fracture Toughness of Aluminum Nitride Ceramics at Cryogenic Temperatures

Effects of Presintering Temperature and Heating Rate on the Physical and Mechanical Properties of Alumina-Glass-Composites

Cryogenic Mechanical Properties of Machinable Mica Glass Ceramic

Enhanced Mechanical Properties of Machinable Mica Glass Ceramics at Cryogenic Temperatures

Role of Cryogenic Temperature on the Strengthening Mechanism of Sicw-Al2o3 Composites

Mechanical and fracture properties of alkali-activated concrete exposed to cryogenic temperature

Effects of crystallization of inter-granular glassy phase on the mechanical performance of alumina ceramics

Research of Mechanical and Thermal Properties of SiC at Cryogenic Temperatures

Effect of trace alumina on mechanical, dielectric, and ablation properties of fused silica ceramics

Microstructure and Mechanical Properties of an Alumina–glass Low Temperature Co-Fired Ceramic

The cryogenic mechanical property deviation of Ti-based bulk metallic glass composite induced by interstitial element

The Reinforcing Effect of Graphene Nano-Platelets on the Cryogenic Mechanical Properties of GNPs/Al2O3 Composites

Temperature-Induced Variations in Slip Behavior of Single Crystal Aluminum: Microstructural Analysis