Abstract:An atomically thick AlN layer is typically used as the strain compensation layer (SCL) for InGaN-based-red light-emitting diodes (LEDs). However, its impacts beyond strain control have not been reported, despite its drastically different electronic properties. In this Letter, we describe the fabrication and characterization of InGaN-based red LEDs with a wavelength of 628 nm. A 1-nm AlN layer was inserted between the InGaN quantum well (QW) and the GaN quantum barrier (QB) as the SCL. The output power of the fabricated red LED is greater than 1 mW at 100 mA current, and its peak on-wafer wall plug efficiency (WPE) is approximately 0.3%. Based on the fabricated device, we then used numerical simulation to systematically study the effect of the AlN SCL on the LED emission wavelength and operating voltage. The results show that the AlN SCL enhances the quantum confinement and modulates the polarization charges, modifying the device band bending and the subband energy level in the InGaN QW. Thus, the insertion of the SCL considerably affects the emission wavelength, and the effect on the emission wavelength varies with the SCL thickness and the Ga content introduced into the SCL. In addition, the AlN SCL in this work reduces the LED operating voltage by modulating the polarization electric field and energy band, facilitating carrier transport. This implies that heterojunction polarization and band engineering is an approach that can be extended to optimize the LED operating voltage. We believe our study better identifies the role of the AlN SCL in InGaN-based red LEDs, promoting their development and commercialization.

AlGaInP light-emitting diodes with SACNTs as current-spreading layer

GaInN Light-Emitting Diodes with Omni-Directional Reflector Using Nanoporous SnO2 Film

Study of Carbon Nanotubes As Etching Masks and Related Applications in the Surface Modification of GaAs-based Light-Emitting Diodes

Study of a GaN/InGaN-based Light Emitting Diode with an Indium Gallium Oxide Current Blocking Layer, Silver Nanoparticles, and a Gallium Oxide Surface Passivation Layer

Hybrid Film of Silver Nanowires and Carbon Nanotubes As A Transparent Conductive Layer in Light-Emitting Diodes

Improved electro-optical and photoelectric performance of GaN-based micro-LEDs with an atomic layer deposited AlN passivation layer.

Performance Improvement of InGaN LEDs by Using Strain Compensated Last Quantum Barrier and Electron Blocking Layer

Efficient Dislocation Prevention and Thermal Transport Network Constructed by CNT Films on PSS for GaN-Based UV LEDs

Performance Enhancement of Ingan-Based Light-Emitting Diodes with Ingan/Alinn/Ingan Composition-Graded Barriers

Effect of the AlN strain compensation layer on InGaN quantum well red-light-emitting diodes beyond epitaxy

Study of GaN-Based Light-Emitting Diode (LED) With a Hybrid Surface Structure

Light-extraction enhancement of GaN-based 395 nm flip-chip light-emitting diodes by an Al-doped ITO transparent conductive electrode

Enhanced performance of GaN-based ultraviolet light emitting diodes with ITO/graphene/ITO transparent conductive layer

The impacts of SiO 2 atomic-layer-deposited passivation layer thickness on GaN-based green micro-LEDs

Increase in the efficiency of III-nitride micro LEDs by atomic layer deposition.

Effect of AlGaN interlayer in bottom quantum barriers on efficiency enhancement of InGaN green light-emitting diodes

Efficiency improvement analysis of nano-patterned sapphire substrates and semi-transparent superlattice contact layer in UVC light-emitting diodes

Improved Performance of AlGaInP Red Micro Light-Emitting Diodes by Sidewall Treatments of Citric Acid

Improving AlGaInP Micro-LEDs Characteristics via Varied Dielectric Passivation Layers

InGaN/GaN Ultraviolet LED with a Graphene/azo Transparent Current Spreading Layer

Impact of Carbon Nanotube Pattern Layers on Gallium Nitride-Based Light Emitting Diodes