Abstract:GaN-based light-emitting diodes provide higher performance in the short-wavelength part of the visible and ultraviolet spectrum than any other material system. However, there is still a great need for improvement of the extraction efficiency. Because many parts of emitting light of LED suffer absorption of the metal contacts and bond pads, also by active layer. So the employment of highly reflective metal ohmic contacts with a low contact resistance could substantially improve the GaN extraction efficiency of GaN-based LED, especially for vertical structure LED fabricated by laser lift-off process, which have more light output surface and high thermal conductivity than normal structure LED. The high reflectivity of omni-direction reflector is reported, that is, incorporation of Ag and Al onto the contact layers acting as a reflecting layer. Firstly, the reflectivity of the layers Ti/Ag, Al, Ni/Au/Ti/Ag and Ni/Au/Al were calculated through the theory of optical films. Then the reflectivity and contact characteristic of the GaN-based LED samples with these multi-layers on p-type GaN were measured. The result showed high omni-directional reflectors can be achieved over Ag-based films structure, and Al-based also, but the Ag-based films can provide higher reflectivity of 80%, which is better than that of Al-based film. The current-voltage curves showed low resistance on these contact layers except the Al direct on p-GaN. And the resistance of Ni/Au/Ti/Ag and Ni/Au/Al just depends on the annealed Ni/Au layers. Here the Ni/Au layers not only supply the ohmic contact but also the spreading the current. The conglomerate and oxidation of Ag film under high temperature are eliminated by introducing other Ni/Au cladding layers. Because the thickness of Ag is enough for high reflectivity so the additional layers after Ag also have no effect on the reflectivity. The good stability, low resistance and high reflectivity were obtained by two-step annealing methods. Then we applied the multi-layer Ni/Au/Ti/Ag/NiAu to vertical structure light emitting diodes (LED) by laser lift-off technology. The light output efficiency was improved significantly. The vertical structure LED with high reflective contact layer was fabricated successfully.

GaInN Light-Emitting Diodes with Omni-Directional Reflector Using Nanoporous SnO2 Film

Optical and Electrical Properties of the LED Using ZnO:Ga Film As Current Diffusion Layer by Sol-gel Technique

High-output power GaN-LED based on surface plasmon enhancement

Surface-plasmon-enhanced GaN-LED based on the multilayered rectangular nano-grating

Light Extraction Efficiency Enhancement of GaN-based Light Emitting Diodes by a ZnO Current Spreading Layer

Study of a GaN/InGaN-based Light Emitting Diode with an Indium Gallium Oxide Current Blocking Layer, Silver Nanoparticles, and a Gallium Oxide Surface Passivation Layer

Light Extraction Enhancement of GaN LEDs by Hybrid ZnO Micro-Cylinders and Nanorods Array

Light-extraction enhancement of GaN-based 395 nm flip-chip light-emitting diodes by an Al-doped ITO transparent conductive electrode

Tuning the emission of ZnO nanorods based light emitting diodes using Ag doping

Light Extraction Efficiency Enhancement of GaN-based Blue LEDs Based on ITO/ InxO Ohmic Contacts with Microstructure Formed by Annealing in Oxygen.

Effect of ITO Interface Modulation Layer on the Performances of LEDs with Ga-doped ZnO Electrode

Simulation of Nanoscale ITO Top Grating of GaN LED

Performance Improvement of AlGaInP Based Red LEDs by Combination of Omnidirectional Mirror and AuZn Micro-contacts

Preparation and Increased Optical Properties of Large-Area AlInGaN LEDs with Mesoporous AlGaN-Distributed Bragg Reflectors

Light-output enhancement of InGaN light emitting diodes regrown on nanoporous distributed Bragg reflector substrates

Slanted n-ZnO/p-GaN nanorod arrays light-emitting diodes grown by oblique-angle deposition

Study on Light Extraction from GaN-based Green Light-Emitting Diodes Using Anodic Aluminum Oxide Pattern and Nanoimprint Lithography

Ohmic Contact of High Reflectivity on P-Type GaN

Study of GaN-Based LEDs With Hybrid SiO2 Microsphere/Nanosphere AntiReflection Coating as a Passivation Layer by a Rapid Convection Deposition

Light extraction enhancement of light-emitting diodes by nanopillar hierarchical structures

Light Extraction Improvement of InGaN Light-Emitting Diodes with Large-Area Highly Ordered ITO Nanobowls Photonic Crystal Via Self-Assembled Nanosphere Lithography