Abstract:A radio-frequency micro-electro-mechanical system (RF MEMS) wafer-level packaging (WLP) method using pre-patterned benzo-cyclo-butene (BCB) polymers with a high-resistivity silicon cap is proposed to achieve high bonding quality and excellent RF performance. In this process, the BCB polymer was pre-defined to form the sealing ring and bonding layer by the spin-coating and patterning of photosensitive BCB before the cavity formation. During anisotropic wet etching of the silicon wafer to generate the housing cavity, the BCB sealing ring was protected by a sputtered Cr/Au (chromium/gold) layer. The average measured thickness of the BCB layer was 5.9 mu m. In contrast to the conventional methods of spin-coating BCB after fabricating cavities, the pre-patterned BCB method presented BCB bonding layers with better quality on severe topography surfaces in terms of increased uniformity of thickness and better surface flatness. The observation of the bonded layer showed that no void or gap formed on the protruding coplanar waveguide (CPW) lines. A shear strength test was experimentally implemented as a function of the BCB widths in the range of 100-400 mu m. The average shear strength of the packaged device was higher than 21.58 MPa. A RF MEMS switch was successfully packaged using this process with a negligible impact on the microwave characteristics and a significant improvement in the lifetime from below 10 million to over 1 billion. The measured insertion loss of the packaged RF MEMS switch was 0.779 dB and the insertion loss deterioration caused by the package structure was less than 0.2 dB at 30 GHz.

Development of RF MEMS switch on flexible organic substrate with wafer transfer technology (WTT)

3D Heterogenous Integrated Wideband Switchable Bandpass Filter Bank for Millimeter Wave Applications

An Ultra-Broadband Contact-Capacitive RF MEMS Switch for 15-110GHZ Applications

Novel Process for Fabrication of RF MEMS Switch with High Mechanical Reliability

Design and fabrication of X-band capacitive MEMS switches

Research status of wafer level packaging for RF MEMS switches

Electro-thermally actuated RF MEMS switch for wireless communication.

Stress Suppression Design for Radiofrequency Microelectromechanical System Switch Based on a Flexible Substrate

Low-voltage Micromachining-Based Scalable Optical Switch

Rf Mems Activities at Imetu

A dielectric-bridge-type MEMS series contact switch for 0-10GHz applications

Design and Fabrication of DC to 30 GHz DC-contact Shunt RF MEMS Switch

Wafer-Level Packaging Method For Rf Mems Applications Using Pre-Patterned Bcb Polymer

Monolithic Integration of a Wafer-Level Thin-Film Encapsulated mm-Wave RF-MEMS Switch in BEOL of a 130-nm SiGe BiCMOS Technology

Rf Mems Switch and Its Applications

Mitigation of substrate coupling effects in RF switch by localized substrate removal using laser processing

A low-loss RF MEMS switch with dielectric layer on the lower surface of the bridge

Power Handling Capability Enhanced RF MEMS Switch Using Modified-Width Cantilevers Structure

Flexible-Grid Wavelength-Selective Switch Based on Silicon Microring Resonators with Interferometric Couplers

Implementation of Highly Reliable Contacts for RF MEMS Switches

Design and Fabrication of a Capacitive Series RF MEMS Switch