Abstract:We demonstrate the fabrication of $\sim$1.08 $\mu$m deep microfluidic cavities with characteristic size as large as 7 mm $\times$ 11 mm or 11 mm diameter, using a silicon$-$glass anodic bonding technique that does not require posts to act as separators to define cavity height. Since the phase diagram of $^3$He is significantly altered under confinement, posts might act as pinning centers for phase boundaries. The previous generation of cavities relied on full wafer-bonding which is more prone to failure and requires dicing post-bonding, whereas the these cavities are made by bonding a pre-cut piece of Hoya SD-2 glass to a patterned piece of silicon in which the cavity is defined by etching. Anodic bonding was carried out at 425 $^{\circ}$C with 200 V, and we observe that pressurizing the cavity to failure ($>$ 30 bar pressure) results in glass breaking, rather than the glass-silicon bond separation. In this article, we discuss the detailed fabrication of the cavity, its edges, and details of the junction between the coin silver fill line and the silicon base of the cavity that enables a low internal-friction joint. This feature is important for mass coupling torsional oscillator experimental assays of the superfluid inertial contribution where a high quality factor ($Q$) improves frequency resolution. The surface preparation that yields well-characterized smooth surfaces to eliminate pinning sites, the use of transparent glass as a cover permitting optical access, low temperature capability and attachment of pressure-capable ports for fluid access may be features that are important in other applications.

Micromachining of Pyrex 7740 Glass by Silicon Molding and Vacuum Anodic Bonding

Micro Aspheric Glass Lens Molding Process

Design and Fabrication of High Performance Wafer-Level Vacuum Packaging Based on Glass–silicon–glass Bonding Techniques

Pyrex Glass Wet Deep Etching and Surface Wiring

Micro Fabrication of Micro Fluidic Glass Chip Without Clean Room Condition

Application of PECVD SiC in glass micromachining

Glass Molding for Microstructures

Fabrication of Via-hole on Pyrex7740 Glass Wafer by HF Wet- Etching Technique

Bonding of Glass-Based Microfluidic Chips at Low- or Room-Temperature in Routine Laboratory

Research on Wafer-Level MEMS Packaging with Through-Glass Vias

Implementation of Silicon-on-glass MEMS Devices with Embedded Through-Wafer Silicon Vias Using the Glass Reflow Process for Wafer-Level Packaging and 3D Chip Integration

Fabrication of micro fluidic cavities using Si-to-glass anodic bonding

Electrostatic Bonding of A Silicon Master to A Glass Wafer for Plastic Microchannel Fabrication

Fabrication and Analysis of a Fabry-Perot Cavity with a Micromechanical Wet-Etching Process.

A New Silicon Mold Process for Polydimethylsiloxane Microchannels

Femtosecond pulsed laser micro-machining of glass substrates with application to microfluidic devices

Glass biochip fabrication by laser micromachining and glass-molding process

Fabricating Microstructures on Glass for Microfluidic Chips by Glass Molding Process

Glass Frit Jetting for Advanced Wafer-Level Hermetic Packaging

Silicon-Silicon Anodic Bonding Process With Embedded Glass

Compression molding of glass freeform optics using diamond machined silicon mold