Abstract:This research highlights a superior glass-wet-etch technique which enables a glass wafer to be etched for more than 20 h in 49 wt% hydrofluoric acid (HF) only with Cr/Au film and a common positive photoresist, AZ4330. We demonstrated that pits on the wet-etched glass wafer were generated not only due to HF diffusion through the Cr/Au film but also due to pinholes on the Cr/Au films created by the diffusion of the Cr/Au etchant through a photoresist etching-mask during the Cr/Au wet etching process. These two types of diffusion, HF diffusion and Cr/Au etchant diffusion, were eliminated by the thermal curing of a photoresist (PR), AZ4330, before the Cr/Au wet etching process. The curing process allowed the PR to dehydrate, increased the hydrophobicity, and prevented the diffusion of the hydrophilic HF and Cr/Au etchant. Optimization of the curing process was performed, showing that curing at 130 °C for 20 min was the proper condition. With the optimized process, a 525 µm thick borosilicate glass wafer was penetrated with 49%wt HF. A fused silica wafer 525 µm thick was also wet-etched and penetrated with 49 wt% HF at 10 h. Moreover, no pits were found in wet etching of the fused silica for 20 h in 49 wt% HF. These findings demonstrate that the proposed technique allows the wet etching of a glass wafer for more than 20 h in 49%wt HF, the best result thus far. We fabricated a glass substrate with a 217.0 µm deep cavity and a penetrating through-via using the proposed technique, proving the feasibility of the product as an optical component with a surface roughness of 45.5 Å in the cavity.

Fabrication of Via-hole on Pyrex7740 Glass Wafer by HF Wet- Etching Technique

Wetting Process of Copper Filling in Through Silicon Vias

Research on Wafer-Level MEMS Packaging with Through-Glass Vias

Fabrication and Analysis of a Fabry-Perot Cavity with a Micromechanical Wet-Etching Process.

Fabrication Technology of Micro Through-hole on Silicon Wafer

Fabrication of through holes in silicon carbide using femtosecond laser irradiation and acid etching

Novel Method of Fabricating Fabry-Perot Cavity Employing MEMS Wet-Etching Process

Pyrex Glass Wet Deep Etching and Surface Wiring

Manufacturing of selectively buried channel waveguide on glass substrate

Micro Fabrication of Micro Fluidic Glass Chip Without Clean Room Condition

Fabrication of Micro-Hole Arrays in Silicon Using Femtosecond Laser Irradiation and Acid Etching

Through wafer via technology for 3-D packaging

Implementation of Silicon-on-glass MEMS Devices with Embedded Through-Wafer Silicon Vias Using the Glass Reflow Process for Wafer-Level Packaging and 3D Chip Integration

Design and Fabrication of High Performance Wafer-Level Vacuum Packaging Based on Glass–silicon–glass Bonding Techniques

Etch the Borosilicate Glass to Form a Straight Through-Glass-via Based on the FLACE Technology

Deep wet etching of borosilicate glass and fused silica with dehydrated AZ4330 and a Cr/Au mask

Fabrication of Ultra-Fine Micro-Vias in Non-Photosensitive Polyimide for High-Density Vertical Interconnects

A Wet Etching Approach for the Via-Reveal of a Wafer with Through Silicon Vias

Fabrication of ultra-deep high-aspect-ratio isolation trench without void and its application

Fabrication of PDMS micro through-holes using micromolding in open capillaries

A wet process to etch arrayed vias for through silicon via application of 3D packaging