Abstract:Based on the HVDC power transmission project from Tianshengqiao to Guangzhou the mechanism leading to converter valve overvotage is analyzed and analysis results show that overvoltage will appear at both terminals of the valves under two conditions： the first one is that after turning-off all valves in uppermost layer of commutating group overvoltages appear at both terminals of the valves belonging to this layer, whereas when all valves belonging to other layers of commutating groups are turned-off there in general will not be overvotlages appearing at both terminals of these valves; the second one is that the switching surge due to interphase operation in AC-system will lead to higher overvoltage appearing at both terminals of valves. According to the analysis results, simulation analysis on two typical faults, namely the single-phase short-circuit occurred at upper-half rectifier bridge side of wye-wye connected winding of converter transformer and switching surge caused by interphase operation in AC-system, is performed. Simulation results show that when HVDC system is operated in minimum power transmission mode, the single-phase short-circuit fault occurred at upper-half rectifier bridge side of wye-wye connected winding of converter transformer will lead to higher overvotage at both terminals of valves while the energy passing through valve arrester reaches its maximum value, however, along with the increase of transmitted power the energy passing through valve arrester will decrease; in view of the fact that the transformation ratio of converter transformer configured in rectifier station is higher than that in inverter station, the swithching surge caused by interphase operations in AC system, which possess the same amplitude, will lead to relatively serious overvotlage appearing at both terminals ot converter valves in rectifier station.

Phenomena and Mechanism Analysis on Overvoltages Caused by 40.5-Kv Vacuum Circuit Breakers Switching off Shunt Reactors

Overvoltage Mechanism of Switching off Shunt Reactors for 40.5kV Vacuum Circuit Breakers

Three-Phase Multi-Reignition Phenomenon During 40.5 Kv VCB Switching off Shunt Reactors

Protection for Overvoltage of 40.5 Kv Vacuum Circuit Breaker Switching off Shunt Reactors

DC switching overvoltage of ± 1100 kV UHVDC converter station

Analysis of a 35kV vacuum circuit breaker accident caused by protection misoperation

Reignition overvoltages induced by vacuum circuit breakers and its suppression in offshore wind farms

Study on Transient Overvoltage of Zhexi Converter Station of ±800 Kv DC Power Transmission Project

Research on Converter Valve Overvoltage Mechanism and Calculation Conditions of ± 800 Kv Converter Station

Switching Overvoltage Characteristics of <formula Formulatype="inline"><tex Notation="TeX">$\pm $&Lt;/tex></formula>1100-Kv UHVDC Converter Station

Study on Switching Over-voltage and Its Restrictions in UHVAC System

Overvoltage Mechanism of Converter Valves for HVDC Power Transmission Project from Tianshengqiao to Guangzhou

Overvoltage Estimation by Stray Inductances During Turn-off of a 500 Kv/25 Ka DC Circuit Breaker

Investigation on Multiple Reignitions Caused by Vacuum Circuit Breaker Switching off Shunt Reactor Considering Contact Travel in Offshore Wind Farms

Research on the Influence of Current Limiter Based on Highly Coupled Split Reactor on Main Circuit Breaker Overvoltage

Analysis on Overvoltage in Renovated Control and Protection System for HVDC Power Transmission Project from Tianshengqiao to Guangzhou

Research on Switching Overvoltage Caused by Faults in 1000kV UHV AC Transmission Line

On the DC Transient Overvoltage in the Converter Stations of ±800 Kv Xiluodu Zhexi HVDC Project

Investigation on overvoltage caused by vacuum circuit breaker switching off shunt reactor in offshore wind farms

Circuit breakers 500 kV degradation in substation reactors caused by inductive current

Overvoltage Phenomenon Initiated by Breakdown During On-Site Withstand Voltage Tests of GIL and GIS: Mechanisms and Consequences