Abstract:The high amplitude and steep overvoltage generated by the breaking of the vacuum circuit breaker in the wind farm damages the inter-turn insulation of the transformer. There is a certain difference between the simulation results of the traditional reignition model and the measured overvoltage. It is necessary to improve the simulation model to simulate the overvoltage condition of the transformer more accurately and then select appropriate overvoltage protection measures. In this paper, based on the physical process of dielectric recovery during the opening process of the vacuum circuit breaker, a model of dielectric strength recovery is built to simulate the arc reignition of the vacuum circuit breaker. The model was applied to compare the overvoltage protection effects of RC snubbers, surge arresters, and choke coils. The simulation results show that the overvoltage amplitude and reignition times calculated by the model proposed in this paper are closer to the measured values. Compared with the traditional linear curve reignition model, the accuracy was increased by 24% and 51.2%, respectively. The parameter value of RC snubbers, the connection mode of surge arresters, and the combination mode of choke coil have an influence on overvoltage suppression. Finally, a suitable suppression scheme is proposed by installing a combined arrester on the high-voltage side of the transformer and connecting a choke coil in series, which can limit the phase-to-ground voltage and the phase-to-phase voltage to 2.43 p.u and 3.24 p.u, respectively, and reduce the steepness from 157.2 kV/μs to 22.3 kV/μs.

Investigation on Multiple Reignitions Caused by Vacuum Circuit Breaker Switching off Shunt Reactor Considering Contact Travel in Offshore Wind Farms

Investigation on overvoltage caused by vacuum circuit breaker switching off shunt reactor in offshore wind farms

Reignition overvoltages induced by vacuum circuit breakers and its suppression in offshore wind farms

Investigation on Power Frequency Following Current for Vacuum Circuit Breaker Interrupting Shunt Reactor in Offshore Wind Farms

Simulation and Protection of Reignition Overvoltage in Wind Farm Considering Microscopic Dielectric Recovery Process of Vacuum Circuit Breaker

Three-phase Modeling of 40.5-Kv Vacuum Circuit Breaker Switching off Shunt Reactors and Overvoltage Suppression Measure Analysis

Study on the Influencing Factors of Reignition Characteristics for 40.5kv Vacuum Circuit Breakers

Three-Phase Multi-Reignition Phenomenon During 40.5 Kv VCB Switching off Shunt Reactors

Impact Factor Identification for Switching Overvoltage in an Offshore Wind Farm by Analyzing Multiple Ignition Transients

Overvoltage Mechanism of Switching off Shunt Reactors for 40.5kV Vacuum Circuit Breakers

Investigation of Transient Overvoltage Caused by Circuit Breaker Switching Shunt Reactors in 330 Kv GIS

Novel Method for Restraining 35 Kv Shunt Reactor Switching Overvoltage – Phase Controlled Breaker

Phenomena and Mechanism Analysis on Overvoltages Caused by 40.5-Kv Vacuum Circuit Breakers Switching off Shunt Reactors

Study on Switching Over-voltage and Its Restrictions in UHVAC System

Characteristic Analysis of the VCB Operational Overvoltage for High-Speed Trains Considering Arc Reignition Phenomenon

Overvoltage simulation and analysis of resonant switch in VSC-MTDC system

Study on the Dielectric Recovery Strength of Vacuum Interrupter in MVDC Circuit Breaker

Vacuum circuit breaker modelling for the assessment of transient recovery voltages: Application to various network configurations

Study of Restrike Overvoltage when Switching off Shunt Capacitors in a 10 Kv Distribution System

Trend of Contact Surface Condition in VCB Investigated Using DC Dynamic Gap Measurement Method During Capacitive Switching

A New Measurement Method of Contact Conditions in a Vacuum Circuit Breaker With the Field Emission Current During the Closing Operation