Abstract:Whichever the application field, every material forming process generates residual stresses on the surface. While they are likely to enhance the aimed properties of the final mechanical part, these stresses may also drastically reduce them and result in early failures. Therefore, understanding the residual stress state remains a major challenge when coating complex parts, especially as most characterization methods at the microscopic scale involve specific sample preparation procedures which may affect the residual stresses field. This work investigates the residual stress state that exists in chromium oxide coatings deposited via Atmospheric Plasma Spray (APS), using two pioneering techniques featuring high spatial resolution: Scanning Microwave Microscopy and Raman MicroSpectroscopy. The first technique combines the measurement of microwave electromagnetic capacities of a Vector Network Analyzer with the subnanometric resolution of an Atomic Force Microscope: it thus enables performing depth investigations at very accurately defined positions of the probe on the surface. The second technique relies on the principle of photons inelastic scattering and involves a laser beam aiming at the material sample: it allows a fine characterization of the microstructure as well as defects and stresses detection via molecular vibratory signatures. The investigation scale is limited here to a few cubic micrometers. Due to the highly localized scales of our investigations, which also depend on the device, the objective of our procedure required that the comparison should be made not on individual points but on definite mapped areas, every spot being analyzed and post-treated one after another, with optimum measuring parameters. Results have been correlated with XRD measurements to cross-check the average amount of stress observed over a wider area.

Residual Stress in Thermal Spray Coatings Measured by Curvature Based on 3d Digital Image Correlation Technique

OS13F106 Progress of the Residual Stress Measuring Techniques of Thermal Barrier Coatings

Evolution of Residual Stress Based on Curvature Coupling in Multi-Roll Levelling

Cross-Sectional Residual Stresses in Thermal Spray Coatings Measured by Moiré Interferometry and Nanoindentation Technique

Study on the Correlativity Between Grinding Parameters and Surface Residual Stresses in Ceramic

Study on Measurement Method of Interior Stress Distributions in Engineering Rolled-Plates

Residual Stress Measurement of Thermal Barrier Coatings

Interfacial Residual Stress Analysis of Thermal Spray Coatings by Miniature Ring-Core Cutting Combined with DIC Method

Assessment of non-uniform residual stress field of the thermal sprayed stainless steel coatings on aluminium substrates by the integral hole drilling method

Residual Stress in Cold Spray SS304L Measured Via Neutron Diffraction and Comparison of Analytical Models to Predict the Residual Stress

Finite Element Analysis of Stress Field of Thermal Barrier Coating during the Deposition Process

Effect of Thickness on the Residual Stress Profile of an Aluminum Cold Spray Coating by Finite Element Analysis

A new method for high resolution curvature measurement applied to stress monitoring in thin films

Effect of Top-Coat Thickness and Interface Fluctuation on the Residual Stress in APS-TBCs

Thermal‐cycle Dependent Residual Stress Within the Crack‐susceptible Zone in Thermal Barrier Coating System

Acta Polytechnica

Fast evaluation of the temperature dependence of residual stress in ceramic coatings via an image relative method

Residual Stress Analysis of Cold Spray Coatings Sprayed at Angles Using Through-thickness Neutron Diffraction Measurement

Measurement of the Elastic Modulus and Residual Stress of Thermal Barrier Coatings Using a Digital Image Correlation Technique

Residual Stress Measurement in Thin Films Using a Slitting Method with Geometric Phase Analysis under a Dual Beam (FIB/SEM) System

Measurement and analysis of cold spray residual stress using arbitrary Lagrangian–Eulerian method