Abstract:Whichever the application field, every material forming process generates residual stresses on the surface. While they are likely to enhance the aimed properties of the final mechanical part, these stresses may also drastically reduce them and result in early failures. Therefore, understanding the residual stress state remains a major challenge when coating complex parts, especially as most characterization methods at the microscopic scale involve specific sample preparation procedures which may affect the residual stresses field. This work investigates the residual stress state that exists in chromium oxide coatings deposited via Atmospheric Plasma Spray (APS), using two pioneering techniques featuring high spatial resolution: Scanning Microwave Microscopy and Raman MicroSpectroscopy. The first technique combines the measurement of microwave electromagnetic capacities of a Vector Network Analyzer with the subnanometric resolution of an Atomic Force Microscope: it thus enables performing depth investigations at very accurately defined positions of the probe on the surface. The second technique relies on the principle of photons inelastic scattering and involves a laser beam aiming at the material sample: it allows a fine characterization of the microstructure as well as defects and stresses detection via molecular vibratory signatures. The investigation scale is limited here to a few cubic micrometers. Due to the highly localized scales of our investigations, which also depend on the device, the objective of our procedure required that the comparison should be made not on individual points but on definite mapped areas, every spot being analyzed and post-treated one after another, with optimum measuring parameters. Results have been correlated with XRD measurements to cross-check the average amount of stress observed over a wider area.

Residual Stress in Cold Spray SS304L Measured Via Neutron Diffraction and Comparison of Analytical Models to Predict the Residual Stress

Residual Stress Analysis of Cold Spray Coatings Sprayed at Angles Using Through-thickness Neutron Diffraction Measurement

Measurement and analysis of cold spray residual stress using arbitrary Lagrangian–Eulerian method

Effect of Thickness on the Residual Stress Profile of an Aluminum Cold Spray Coating by Finite Element Analysis

How increasing cold spray coatings thickness affects their residual stress and properties

Numerical analysis of residual stresses induced by cold spray fabricating cBN-reinforced Ni matrix composites

Residual Stress in Thermal Spray Coatings Measured by Curvature Based on 3d Digital Image Correlation Technique

Assessment of non-uniform residual stress field of the thermal sprayed stainless steel coatings on aluminium substrates by the integral hole drilling method

The Effect of Low Temperature Range Heat Treatment on the Residual Stress of Cold Gas Dynamic Sprayed Inconel 718 Coatings via Neutron Diffraction

A Residual Stress-Based Model for Viscoplastic Self-Consistent Simulation of Cold-Sprayed Al6061

On the Surface and System Performance of Thermally Sprayed Carbide Coatings Produced under Controlled Residual Stresses

Comparison of Residual Stress Measurements Conducted by X-ray Stress Analysis and Incremental Hole Drilling Method

Texture-based residual stress analysis of laser powder bed fused Inconel 718 parts

AN INVESTIGATION ON RESIDUAL STRESS IN 316L STAINLESS STEEL BY SELECTIVE LASER MELTING

Analytical Modeling of Residual Stress in Laser Powder Bed Fusion Considering Part’s Boundary Condition

Cross-Sectional Residual Stresses in Thermal Spray Coatings Measured by Moiré Interferometry and Nanoindentation Technique

X-ray Residual Stress Analysis of Nitrided Low Alloyed Steels

The Influence of Spraying Parameters and Powder Sizes on the Microstructure and Mechanical Behavior of Cold-Sprayed Inconel®625 Deposits

Neutron Diffraction Residual Stress Study of a AA2219-T87 Self-Reacting Friction Stir Weld

Influence of Laser Peening Parameters on Residual Stress Field of 304 Stainless Steel

Acta Polytechnica