Abstract:Whichever the application field, every material forming process generates residual stresses on the surface. While they are likely to enhance the aimed properties of the final mechanical part, these stresses may also drastically reduce them and result in early failures. Therefore, understanding the residual stress state remains a major challenge when coating complex parts, especially as most characterization methods at the microscopic scale involve specific sample preparation procedures which may affect the residual stresses field. This work investigates the residual stress state that exists in chromium oxide coatings deposited via Atmospheric Plasma Spray (APS), using two pioneering techniques featuring high spatial resolution: Scanning Microwave Microscopy and Raman MicroSpectroscopy. The first technique combines the measurement of microwave electromagnetic capacities of a Vector Network Analyzer with the subnanometric resolution of an Atomic Force Microscope: it thus enables performing depth investigations at very accurately defined positions of the probe on the surface. The second technique relies on the principle of photons inelastic scattering and involves a laser beam aiming at the material sample: it allows a fine characterization of the microstructure as well as defects and stresses detection via molecular vibratory signatures. The investigation scale is limited here to a few cubic micrometers. Due to the highly localized scales of our investigations, which also depend on the device, the objective of our procedure required that the comparison should be made not on individual points but on definite mapped areas, every spot being analyzed and post-treated one after another, with optimum measuring parameters. Results have been correlated with XRD measurements to cross-check the average amount of stress observed over a wider area.

Cross-Sectional Residual Stresses in Thermal Spray Coatings Measured by Moiré Interferometry and Nanoindentation Technique

OS13F106 Progress of the Residual Stress Measuring Techniques of Thermal Barrier Coatings

Residual Stress Measurement of Thermal Barrier Coatings

Residual Stress in Thermal Spray Coatings Measured by Curvature Based on 3d Digital Image Correlation Technique

Interfacial Residual Stress Analysis of Thermal Spray Coatings by Miniature Ring-Core Cutting Combined with DIC Method

Effect of Top-Coat Thickness and Interface Fluctuation on the Residual Stress in APS-TBCs

Growth selection induced residual stresses and fracture behavior of as‐deposited thermal barrier coatings

Numerical and Experimental Investigation of Residual Stress in Thermal Barrier Coatings During Aps Process

Simulation of Residual Stresses and Their Effects on Thermal Barrier Coating Systems Using Finite Element Method

Acta Polytechnica

Assessment of non-uniform residual stress field of the thermal sprayed stainless steel coatings on aluminium substrates by the integral hole drilling method

Mechanical Properties and Residual Stress Measurement of TiN/Ti Duplex Coating Using HiPIMS TiN on Cold Spray Ti

Residual Stress Analysis of Cold Spray Coatings Sprayed at Angles Using Through-thickness Neutron Diffraction Measurement

Research on the contact fatigue failure of thermal sprayed coating based on infrared thermography

Precise Strain Profile Measurement As a Function of Depth in Thermal Barrier Coatings Using High Energy Synchrotron X-rays

Atmospheric plasma sprayed thick thermal barrier coatings: Microstructure, thermal shock behaviors and failure mechanism

High Temperature Fracture Toughness and Residual Stress in Thermal Barrier Coatings Evaluated by an In-Situ Indentation Method

The failure mechanisms of TBC structure by moiré interferometry

Thermal‐cycle Dependent Residual Stress Within the Crack‐susceptible Zone in Thermal Barrier Coating System

Study on the residual stresses of Ti(C,N) coated WC cutting tools by pulsed high energy density plasma gun

Finite Element Analysis of Stress Field of Thermal Barrier Coating during the Deposition Process