Measurement and analysis of cold spray residual stress using arbitrary Lagrangian–Eulerian method

Qian Wang,Xiaotao Luo,Seiichiro Tsutsumi,Toshihiko Sasaki,Changjiu Li,Ninshu Ma

DOI: https://doi.org/10.1016/j.addma.2020.101296

IF: 11

2020-10-01

Additive Manufacturing

Abstract:<p>Cold spray (CS) residual stress was measured by the X-ray diffraction (XRD) and contour methods. The residual stress components SX and SY, perpendicular to the thickness, have similar distributions and approximately equal magnitudes. Both are compressive on the deposited surface and become tensile inside the structure. An advanced simulation model based on the arbitrary Lagrangian–Eulerian (ALE) method was developed to investigate the residual stress distributions in a single CS microparticle and multi-layer CS microparticles and reveal the formation mechanism. The residual stress components SX and SY predicted by the proposed simulation model have the same distribution as shown by the measurements, i.e., compressive on the surface and tensile inside. As the number of deposition layers increases, the position of maximum tensile stress moves from the substrate to the deposited layers. The residual stress component SZ in the direction of the deposition thickness shows alternate tensile and compressive distributions in the transverse direction, which is quite different from that of the transverse component. The formation of CS residual stress is mainly affected by three aspects: the collisions among microparticles, the interactions between microparticles in the same layer, and interactions between microparticles in different layers. The present work provides a guideline for effectively tailoring the residual stress in CS parts and thereby improving the fatigue lifetime.</p>

engineering, manufacturing,materials science, multidisciplinary