Abstract:A spray reactor in which the liquid phase containing dissolved p-xylene (pX) and the catalyst is dispersed as fine droplets by a nozzle into a continuous vapor phase containing the oxidant (O2) is shown to produce high-purity terephthalic acid (TPA) with less than 25ppm 4-carboxybenzaldehyde (4-CBA) in the solid TPA product. In sharp contrast, the solid TPA product obtained from a conventional stirred reactor similar to the configuration used in the conventional Mid-Century (MC) process contains nearly 1000ppm 4-CBA even though the reactor is operated at similar pressure and temperature (15bar and 200°C) but with the gas phase dispersed into the liquid phase. The dramatic improvement in TPA product quality during spray reactor operation is attributed to two main factors: the alleviation of interphase gas–liquid mass transfer limitations that facilitates more complete oxidation of the pX and the intermediate oxidation products to TPA, and reduced backmixing that enhances the oxidation rates. Theoretical calculations show that the time constants for O2 diffusion in typical spray droplets (50μm diameter) is 1–2 orders of magnitude lower than the kinetic rate constant confirming complete O2 penetration and saturation of the droplets. Further, the usage of CO2 as an inert gas and the dominance of acetic acid (>50mol.%) in the vapor phase under reaction conditions create an environment that falls outside of the flammability envelope. Mathematical modeling of the stirred reactor using MC process conditions accurately predicts the steady state temperatures observed in industrial reactors. The model also clearly divulges that the cooling provided by partial evaporation of the acetic acid solvent is vital to maintain stable steady state operation. By eliminating the need for a hydrogenation step, the spray reactor has the potential to not only reduce capital and operating costs but also provide environmental benefits.

Production of Acrylic Acid Via Catalytic Partial Oxidation of Propylene in a Two-stage Fluidized Bed

Epoxidation of propylene to propylene oxide catalyzed by μ-oxo-bismetalloporphyrins

PROPYLENE AMMOXIDATION UNDER FORCED PERIODIC OSCILLATIONS OF OXYGEN CONCENTRATION

Ammoxidation of Propylene to Acrylonitrile in a Bench-Scale Circulating Fluidized Bed Reactor

Effective treatment of residue of acrylic acid production using a fluid‐bed/fixed‐bed system with low energy consumption

Direct Oxidation Of Propane To Acrolein Over Bimo Based Catalysts

Highly Efficient Production of Acrylic Acid by Sequential Dehydration and Oxidation of Glycerol

Renewable Production of Acrylic Acid and Its Derivative: New Insights into the Aldol Condensation Route over the Vanadium Phosphorus Oxides

Propene ammoxidation over an industrial bismuth molybdate-based catalyst using forced dynamic operation

Gas Phase Epoxidation Of Propylene Over Amodified Ag/Alpha-Al2o3 Catalyst

In Situ DRFTIR Study of Propylene Selective Oxidation

Direct epoxidation of propylene by molecular oxygen over Y2O3 and K2O-promoted Ag/α-Al2O3 catalyst

Microporous Inert Membrane Packed-Bed Reactor for Propylene Epoxidation with Hydrogen and Oxygen: Modelling and Simulation

Design and optimization of a catalytic membrane reactor for the direct synthesis of propylene oxide

Enhanced Production of Aromatics from Propane with a Temperature-Shifting Two-Stage Fluidized Bed Reactor.

Study on Dynamic Model and Optimization of Propylene Ammoxidation under the Forced Periodic Oscillations of Oxygen Concentration

An study on possibility to convert CO2 and acetylene to acrylic acid

A spray reactor concept for catalytic oxidation of p-xylene to produce high-purity terephthalic acid

Epoxidation of propylene to propylene oxide catalyzed by large-grain TS-1 in supercritical CO2

Characterization and catalytic performance of supported molybdophosphoric acid catalysts for the oxidation of propylene to acetone

Turbulent fluidized bed reactor, device and method for preparing propylene and C4 hydrocarbons from oxygen containing compound